Gas Connection; Electrical Connection - KitchenAid KHDD 3020 Instructions For Use Manual

Hide thumbs


Gas connection

The gas supply system must comply with local regulations.
• You can find specific local regulations for some countries in the
paragraph "Relevant National Regulations.
• If no information concerning your Country is given, please ask your
installer for details.
Connection to the mains gas network must be carried out by a
qualified and competent technician, in compliance with local
• The connection of the hob to the mains gas network or gas
cylinder must be made by means of a rigid copper or steel pipe
with fittings complying with local regulations, or by means of a
continuous-surface stainless steel hose complying with local
regulations. The maximum length of the steel hose is 2 linear
A Gas supply
B Gas hob manifold
IMPORTANT: if a stainless steel hose is used, it must be
installed so as not to touch any mobile part of the furniture. It
must pass through an area free from obstructions and permit
inspection along the entire length.
• After connection to the gas supply, check for leaks with soapy
water. Light up the burners and turn the knobs from max position
to minimum position

Electrical connection

This operation must be performed by a qualified technician.
• The electrical connections must comply with local
• The earthing of this appliance is compulsory by law.
• Do not use extension cables.
IMPORTANT: information on voltage and power absorption are
given on the rating plate.
to check flame stability.



Table of Contents