Proliant 300 And 500 Series Servers Hdd Configuration - HP ProLiant ML110 G1 User Manual

configured by default into two logical disks at the controller level as
described in Table
Table 10 ProLiant 300 and 500 series servers HDD
configuration
Logical RAID level
disk
1 RAID 1
2
RAID 1
ML350 G4p (SATA) model only:
1
RAID 1
2 RAID 1
NOTE:
In the HP Array Configuration Utility (ACU) and Adaptec Storage
Manager (ASM), logical disks are labeled 1 and 2. In Disk Manager,
logical disks are displayed as 0 and 1. The ACU user guide is available
for download at
SupportManual/c00294139/c00294139.pdf. For ASM configuration
information, the ASM installation and user's guide can be obtained from
http://download.adaptec.com/pdfs/user_guides/aar2410Sa_iug.pdf.
NOTE:
The DON'T ERASE logical disk supports the Quick Restore process
only and does not host the secondary operating system. If you need to
perform a quick restore of your server, see the Quick Restore Instructions
inside the Quick Restore DVD. Be sure to back up your user data, and
then use the Quick Restore DVD to restore the server to the factory
default state
Data volumes are not carved at the factory or by the Quick Restore DVD,
and must be configured manually by the end user. Refer to the HP ProLiant
Storage Server administration guide for additional information.
46
Default storage configurations
10.
27 GB across physical drive
0, 1
7 GB across physical drive 0,
1
65 GB across physical drive
0, 1
9.3 GB across physical drive
0, 1
http://h200002.www2.hp.com/bc/docs/support/
Size/allocation
Purpose
Primary OS
DON'T
ERASE
Primary OS
DON'T
ERASE