Download  Print this page

AEG A92300HLW0 User Manual page 27

Hide thumbs

Advertisement

Table of Contents
Problem
The lid doesn't close
completely.
The lid is difficult to
open.
The lamp does not
work.
It is too warm in the
freezer.
Possible cause
The lid is not shut proper-
ly or do not close tightly.
The temperature is not
set correctly.
The water drainage plug
is not correctly posi-
tioned.
There is excessive frost.
The lid gaskets are dirty
or sticky.
Food packages are block-
ing the lid.
The lid gaskets are dirty
or sticky.
The valve is blocked.
The lamp is defective.
The temperature is not
set correctly.
The lid does not close
tightly or it is not shut
properly.
Before freezing the appli-
ance was not precooled
sufficiently.
Large quantities of food
to be frozen were put in
at the same time.
Food placed in the appli-
ance was too warm.
Products to be frozen are
placed too closely to
each other.
The lid has been opened
often.
The lid has been opened
for a long time.
ENGLISH
Solution
Check if the lid closes well
and the gaskets are un-
damaged and clean.
Set a warmer temperature.
Position the water drain-
age plug in the correct
way.
Eliminate excess frost.
Clean the lid gaskets.
Arrange the packages in
the right way, see the stick-
er in the appliance.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the
lamp".
Set a lower temperature.
Check if the lid closes well
and the gasket is undam-
aged and clean.
Pre-cool the appliance for
enough time.
Wait some hours and then
check the temperature
again. Next time insert
smaller quantities of food
to be frozen at any one
time.
Allow food to cool to room
temperature before stor-
ing.
Place the products in a way
so that cold air could circu-
late among them.
Try to not open the lid of-
ten.
Do not leave the lid open
longer than necessary.
27

Advertisement

Table of Contents
loading

  Related Manuals for AEG A92300HLW0