Table of Contents
Advertisement
1. Slide the release button and the DDIC will pop up slightly from the slot, as shown in the following
figure.
Figure 7. Removing a DDIC
2. Lift the DDIC out of the slot.
Installing and removing cooling modules, power supply units, and
compute modules
Observe proper safety precautions when replacing any of these modules.
CAUTION:
Handle the modules carefully and avoid damaging the connector pins. Do not install if any pins
appear to be bent.
CAUTION:
Do not remove these modules unless a replacement can be immediately added. The system must not
be run without all modules in place.
Remove a cooling module
1. Depress the retaining latch, as shown in the following figure.
Figure 8. Removing a cooling module (1)
2. Pull the cooling module handle until the unit is completely free of the enclosure, as shown in the
following figure.
Chapter 3. Installing the appliance into a rack
11
Advertisement
Table of Contents
