Pair Up With The Subwoofer - Philips 6000 Series User Manual

Pair up with the
subwoofer
Automatic Pairing
Plug the Soundbar and the subwoofer into the
mains sockets and then press on the unit or
remote control to switch the unit to ON mode.
The subwoofer and Soundbar will automatically
pair.
Determine the status based on the
wireless subwoofer indicator.
LED State Status
Fast blink Subwoofer in pairing mode
Constant on Connected / Pairing successful
Slow blink Connection / Pairing Failed
Tips
•
Do not press Pair on the rear of the subwoofer, except
for manual pairing.
Manual Pairing
If no audio from the wireless subwoofer can be
heard, manually pair up the subwoofer.
1
Unplug both units from the mains sockets
again, then plug them in again after 3 minutes.
2
Press and hold the Pair button on the rear
of the subwoofer for a few seconds.
The Pair indicator on the subwoofer
will rapidly blink.
3
Then press on the unit or remote
control to switch the unit ON.
The Pair indicator on the subwoofer
will become solid when successful.
4
If the Pair indicator still keeps blinking,
repeat step 1-3.
Tips
•
The subwoofer should be within 6 m of the Soundbar in
an open area (the closer the better).
•
Remove any objects between the subwoofer and the
Soundbar.
•
If the wireless connection fails again, check if there is a
conflict or strong interference (e. g. interference from
an electronic device) around the location. Remove these
conflicts or strong interferences and repeat the above
procedures.
•
If the main unit is not connected with the subwoofer
and it is in ON mode, the unit' s STANDBY indicator
will flash.
11