MasterCool 52225-MED Operating Instructions Manual page 11

Multi-function medical/surface infrared thermometer
Table of Contents

Advertisement

EMPFOHLENE TRENNUNGSABSTÄNDE ZWISCHEN TRAGBARER UND MOBILER HF-AUSRÜSTUNG UND DEM
Manufacturer's declaration – electromagnetic immunity
THERMOMETER
The THD2FE is intended for use in the electromagnetic environment (for home healthcare) spec
Vorgesehen für die Verwendung in einer elektromagnetischen Umgebung (für häusliche Gesundheitsversorgung), in welcher
abgestrahlte HF-Störgrößen geregelt sind. Der Kunde oder Benutzer kann dabei helfen, elektromagnetische Störung zu
should assure that it is used in such an environment.
verhindern, indem er einen Mindestabstand zwischen tragbarer und mobiler HF-Kommunikationsausrüstung (Transmitter)
Compliance
IEC 60601 test level
Immunity test
und dem Gerät wie unten beschrieben einhält, gemäß der maximalen Ausgangsnennleistung der Kommunikationsausrüstung.
level
MAXIMALE
10 V/m
10 V/m
Radiated RF
AUSGANGSNENNLEISTUNG
80 MHz – 2,7
80 MHz – 2,7 GHz
IEC 61000-4-3
DES TRANSMITTERS (W)
0,01
80 % AM at 1 kHz
GHz
0,1
80 % AM at 1
1
kHz
10
100
Für Transmitter mit einer maximalen Ausgangsnennleistung, die nicht oben aufgeführt ist, kann der empfohlene
Trennungsabstand in Meter (m) mit der für die Transmitterfrequenz geltenden Gleichung geschätzt werden, wobei, laut
Hersteller, P die maximale Ausgangsnennleistung des Transmitters in Watt (W) ist.
ANMERKUNG1 Bei 80 MHz und 800 MHz gilt der Trennungsabstand für den höheren Frequenzbereich.
ANMERKUNG2 Diese Richtlinien gelten möglicherweise nicht in allen Situationen. Die elektromagnetische Ausbreitung wird
beeinflusst durch Absorption und Reflexion von Baukörpern, Gegenständen und Personen.
HERSTELLERERKLÄRUNG - ELEKTROMAGNETISCHE STÖRFESTIGKEITSPRÜFUNG SPEZIFIKATIONEN FÜR
NOTE1 At 80 MHz and 800 MHz, the higher frequency range applies.
STÖRFESTIGKEIT DES GEHÄUSEANSCHLUSSES ZU DRAHTLOSER HF-KOMMUNIKATIONSAUSRÜSTUNG
NOTE2 These guidelines may not apply in all situations. Electromagnetic propagation is affe
Vorgesehen für die Verwendung in der unten angegebenen elektromagnetischen Umgebung (für häusliche
and people.
Gesundheitsversorgung). Der Kunde oder Benutzer sollte sicherstellen, dass es in einer solchen Umgebung verwendet wird.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telepho
PRÜFFRE-
radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess th
BAND a)
QUENZ
(MHz)
transmitters, an electromagnetic site survey should be considered. If the measured field strength
(MHz)
applicable RF compliance level above, the THD2FE should be observed to verify normal operat
measures may be necessary, such as re-orienting or relocating the THD2FE.
385
380 - 390 TETRA 400
Recommended separation distances between
450
430 - 470
portable and mobile RF communications equipment and the THD2FE
710
745
704 - 787 LTE Band 13,17
780
810
870
800 - 960
930
1720
1700 -
1845
1990
1970
2400 -
2450
2570
5240
5100 -
5500
5800
5785
ANMERKUNG Falls zum Erzielen der STÖRFESTIGKEITS-PRÜFSTUFE erforderlich, kann der Abstand zwischen der übertragenden
Antenne und der ME AUSRÜSTUNG oder dem ME SYSTEM auf 1 m reduziert werden. Der Testabstand von 1 m ist zulässig durch
IEC 61000-4-3.
a) Bei einigen Diensten sind nur die Uplink-Frequenzen enthalten.
b) Der Betreiber ist mittels eines 50% Testverhältnis-Rechtecksignals zu modulieren.
c) Als Alternative zur FM-Modulation kann 50% Pulsmodulation bei 18 Hz verwendet werden, da, während dies keine tatsächli-
che Modulation darstellt, dies der schlechteste Fall wäre.
Manufacturer's declaration – electromagnetic immunity
Compliance
IEC 60601 test level
level
TRENNUNGSABSTAND GEMÄSS DER FREQUENZ DES TRANSMITTERS (M)
Recommended separation distance:
10 V/m
10 V/m
150 kHz bis 80 MHz
80 MHz – 2,7
80 MHz – 2,7 GHz
d = 1,2
d = 1,2
N/A
GHz
80 % AM at 1 kHz
d = 1,2
80MHz to 800 MHz
N/A
80 % AM at 1
N/A
kHz
d = 2,3
800MHz to 2,7 GHz
N/A
Where P is the maximum output power rating of the transmitter in watts (W) accord
N/A
the transmitter manufacturer and d is the recommended separation distance in met
(m).
Field strengths from fixed RF transmitters, as determined by an electromagnetic sit
survey,
a
should be less than the compliance level in each frequency range.
Interference may occur in the vicinity of equipment marked with the following
symbol:
and people.
DIENST
MODULATION
a)
b)
Pulse modulation
b) 18 Hz
FM c)
Recommended separation distances between
GMRS 460,
±5 kHz deviation
FRS 460
portable and mobile RF communications equipment and the THD2FE
1 kHz sine
Pulse modulation
b) 217 Hz
GSM 800/900, TETRA
Pulse modulation
800, iDEN 820, CDMA
b) 18 Hz
850, LTE Band 5
GSM 1800; CDMA
1900; GSM 1900;
Pulse modulation
DECT; LTE Band 1, 3,
b) 217 Hz
4, 25; UMTS
Bluetooth, WLAN,
Pulse modulation
802.11 b/g/n, RFID
b) 217 Hz
2450, LTE Band 7
WLAN 802.11
Pulse modulation
a/n
b) 217 Hz
environment.
Manufacturer's declaration – electromagnetic
Compliance
Electromagnetic environment – guidance
(for home healthcare environment)
Recommended separation distance:
10 V/m
80 MHz bis 800 MHz
80 MHz – 2,7
d = 1,2
d = 1,2
0,12
GHz
d = 1,2
0,38
80 % AM at 1
1,2
kHz
d = 2,3
3,8
Where P is the maximum output power rating of the trans
12
the transmitter manufacturer and d is the recommended s
(m).
Field strengths from fixed RF transmitters, as determined
survey,
a
should be less than the compliance level in each
Interference may occur in the vicinity of equipment marke
symbol:
MAXIMALE
LEISTUNG
(W)
1,8
2
portable and mobile RF communications equipment
0,2
2
2
2
0,2
www.mastercool.com
environment.
Electromagnetic environment –
level
(for home healthcare environ
Recommended separation dis
800 MHz bis 2,7 GHz
d = 1,2
d = 2,3
0,23
80MHz to 800 MHz
d = 1,2
0,73
2,3
800MHz to 2,7 GHz
d = 2,3
7,3
Where P is the maximum outpu
23
the transmitter manufacturer an
(m).
Field strengths from fixed RF tra
survey,
Interference may occur in the vic
symbol:
IMMU-
ABSTAND
NITÄTS-
(m)
PRÜFSTUFE
(V/m)
0,3
27
Recommended separation distances bet
0,3
28
0,3
9
0,3
28
0,3
28
0,3
28
0,3
9
environment
Electrom
(for h
80MHz to 800 MHz
800MHz to 2,7 GH
a
should be less than the
b
KONFORMITÄTS-
PEGEL (V/M)
(FÜR HÄUSLICHE
GESUNDHEITSVER-
SORGUNG)
27
28
9
28
28
28
9
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents