Safety Instructions - Zanussi ZWF81440W User Manual

staff kitchen areas in shops, offices and other working
–
environments;
by clients in hotels, motels, bed & breakfast and other
–
residential type environments;
areas for communal use in blocks of flats or in launderettes.
–
Do not exceed the maximum load of 8 kg (refer to the
•
"Programme chart" chapter).
The operating water pressure at the water entry point from the
•
outlet connection must be between 0.5 bar (0.05 MPa) and 8
bar (0.8 MPa).
The ventilation opening in the base must not be covered by a
•
carpet, mat, or any floor covering.
The appliance must be connected to the water mains using the
•
new supplied hose sets, or other new hose sets supplied by
the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service Centre or
similarly qualified persons to avoid an electrical hazard.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to clean
•
the appliance.
Clean the appliance with a moist cloth. Use only neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.

SAFETY INSTRUCTIONS

INSTALLATION
The installation must comply with
relevant national regulations.
• Remove all the packaging and the transit bolts
including rubber bush with plastic spacer.
• Keep the transit bolts in a safe place. If the
appliance is to be moved in the future they must
be reattached to lock the drum to prevent an
internal damage.
• Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
• Follow the installation instructions supplied with
the appliance.
• Do not install or use a damaged appliance.
• Do not install or use the appliance where the
temperature can be less than 0°C or where it is
exposed to the weather.
• The floor area on which the appliance is to be
installed must be flat, stable, heat resistant and
clean.
3