Mitsubishi Electric TC-24B Instruction Book page 24

Usage - Main Menu settings - Restriction settings
Setting the temperature ranges within which the operating
2
temperatures can be set from the local remote controllers
Main Menu > Restriction Settings
Main Menu > Restriction Settings > Set Temperature Range Limit
Show Group Name List button
1
Displays a list of group names in a
pop-up window.
Group buttons
2
Displays group numbers.
Touch the button for a specific group
to edit the settings.
buttons
Use to flip through the pages. (Each
page lists four groups.)
1. Touch the [Set Temperature Range Limit] button on the [Restriction Settings] screen.
2
2. Read the pop-up message, and touch the [OK] button to confirm.
3. Click on the Group button on the [Set Temperature Range Limit] screen to select the groups to
2
change their settings.
4. Touch the [Edit] button.
3
46
1
2
3
• The temperature setting range and the operation mode that can be set depend on the indoor unit and
• The cooling and heating temperature ranges can be set under the following conditions
Edit button
3
Edits the temperature range for the
• Operation from the local remote controllers that are connected to Mr. SLIM® cannot be prohibited
selected group.
• If the temperature limits are set too high or low, the System-Changeover function may not work
Select All button
• The DIDO controller groups, the LOSSNAY groups, and the Air To Water (PWFY) groups do not
Selects all groups.
5. Use the
4
at left to set the range for each operation mode (Cooling,
Heating, and AUTO).
To clear the lower limit, keep hitting the
appears. To clear the upper limit, keep hitting the
until
Not all functions are supported by all local remote
controllers. The
5
functions will be grayed out.
6. Touch the
remote controller models.
- The difference between the cooling and heating upper limit temperatures is equal or greater than
the minimum temperature difference that varies with the indoor unit model.
- The difference between the cooling and heating lower limit temperatures is equal or greater than
the minimum temperature difference that varies with the indoor unit model.
from the TC-24B. Use the button lock function on the controllers instead.
properly and the units may not operate in the expected mode (Cooling or Heating).
When using the System-Changeover function, it is recommended not to use the temperature range
limit function.
support the Set Temperature Range Limit function.
Usage - Main Menu settings - Restriction settings
buttons shown in the pop-up window
4
button until
appears.
buttons for the unsupported
[OK] button to save the settings.
5
button
47