Honeywell VisionPRO 8000 Smart Installation Manual page 4

Performing installer setup
Setup options define the type of system you are installing and preferences for the
display.
When newly installed, the thermostat goes into intstaller setup when first powered.
If re-entering installer setup at a later time, go to menu, installer options, and enter
the passcode (shown on page 2).
1 Follow prompts on the screen to select
the appropriate options.
2 For all installer options, press the s or
t buttons to change the option.
3 Press Next to move to the next setting, and Done when setup is complete.
NOTE: The product data sheets list all installer setup options and is available at
customer.resideo.com.
** The THP9045A1098 C-wire adaptor is used on heat/cool systems when you only have four
wires at the thermostat and you need a fifth wire for a common wire. Use the K terminal in place
of the Y and G terminals on conventional or heat pump systems to provide control of the fan and
the compressor through a single wire—the unused wire then becomes your common wire. See
THP9045 instructions for more information.
4
APPLICATION
residential