Troubleshooting - Atlona AT-HDVS-150-TX-WP Installation Manual

Troubleshooting

1. Can I use this unit with an AT-HDVS-200-RX?
We do not recommend this combination, as this will result in limited functionality of both
products and you will be unable to program settings into either one.
2. How do I program settings into this product?
Settings are programmed into the RX side, using the RX software (included in the AT-HDVS-
150-RX firmware file, under "setup.exe").
3. How do I check the firmware version?
You can check the firmware version of the TX by accessing the On-Screen Display (OSD)
on the RX side. Please note that you will need to have the TX and RX directly connected to
each other via HDBaseT for this to work.
5. How do I update the firmware?
You can update the firmware through USB. Please note that you will need a USB A to Mini B
cable, and you will have to remove the unit's faceplate to access the USB port.
6. Does this device have a webGUI?
No, this unit does not have a webGUI.
7. Is this unit compatible with AMS?
No, this unit is not compatible with AMS.
8. Does this unit support free-running analog audio?
No. Analog audio on the AT-HDVS-150-TX-WP requires a VGA signal.
atlona.com
5
Toll free: 1-877-536-3976
Local: 1-408-962-0515