Transport, storage and recycling regulations
The equipment should be stored in protected areas against
Whenever applicable, the EU 2002/96/EC directive
imposed and the differentiated collection / gathering of
used electrical and electronic equipment.
Installation, power connection and
commissioning must only be carried out by a
service approved for such work by the local
▶ Do not drop the appliance.
▶ Remove the appliance from the
packaging only at the place of
▶ Wherever applicable, comply with the
IEC 60364-7-701 norm on installing the
appliance and / or any electric
CAUTION: Damage to the heating elements!
▶ Firstly connect all the water connections
and fill the appliance.
▶ Connect the appliance to the electric
point, assuring connection to earth
Siting the appliance
▶ Chose a sufficiently robust wall to
support the appliance with the tank full,
Regulations concerning the installation site
▶ Comply with country-specific requirements.
▶ Never install the appliance above a heat source.
▶ Never install the appliance in rooms where the ambient
temperature can fall below 0 °C.
▶ Do not install the appliance in locations where the altitude
is above 5000 m.
Tronic – 6 720 816 255 (2018/06)
▶ Install the appliance near the most frequently used draw-
off point to keep energy losses and waiting times to a
▶ Install the appliance in a room that permits the replacement
of the magnesium anode, and necessary maintenance
Protection area 1
▶ Do not install in protection area 1.
▶ Install the appliance outside the protection area.
▶ Make sure that the appliance is
connected to the DB board (electrical
board) with a connection to the earth
NOTICE: Material damage!
▶ Use sleeves and hooks (according with
the type of wall) that can hold the
appliance with the tank full ( page 6).