OPERATION OF FORM GENERATOR... 9 BASIC OPERATION....9 MAINTENANCE....10 STOREAGE......10 14019E (1) 2010-12 A USER MANUAL TABLE OF CONTENTS ENGLISH DF-100A-EU...
TARGET This Manual is intended for operators and technicians qualified to perform the machine maintenance. The operators must not perform procedures reserved for qualified technicians. Viper will not be answerable for damages coming from the non-observance of this prohibition. HOW TO KEEP THIS MANUAL The User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can cause damage to it.
CHANGES AND IMPROVEMENTS Viper constantly improves its products and reserves the right to make changes and improvements at its discretion without being obliged to apply such benefits to the machines that were previously sold. Any change and/or addition of accessories must be approved and performed by Viper.
– To avoid any risk, if the power supply cable is damaged, contact Viper Service Center or a qualified technician. – Do not pull or carry the machine by the power supply cable and never use the power supply cable as a handle. Do not close a door on the power supply cable, or pull the power supply cable around sharp edges or corners.
Page 6
• is wet or has been dropped into water turn it off immediately and contact Viper Service Center or a qualified technician. – If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
Voltage Frequency Power Current IP Class Volume of solution tank Sound pressure level at workstation Weight Length of Power cord 14019E (1) 2010-12 A USER MANUAL ENGLISH DF-100A-EU 230V 50HZ 150W 1.0 A IP 44 6 Liters 68dB(A) 1.0m DF-100A-EU...
Please follow the instructions to achieve the top performance. 1] Installation: a. Set Viper VE Model Polishers (A) at the up-right position and install 2 sets Accessory Clamp (C) on the tube of polisher. b. Install the Foam Generator (B) on the polisher.
5] Please empty the tank after each usage. Remaining chemical may cause chemical residue and operating failure. STORAGE 1] Unplug machine from power source. 2] Store machine in upright position and in a dry area. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities DF-100A-EU 14019E (1) 2010-12 A...