Table 5.3: Charging Status (Continued)
Fast Flash Red
If battery is inserted into a successfully powered
up charger, battery may have bad contact with
Battery under voltage recovery time out
Loss of charge current control
Excessive power supply voltage
Fault connection happened
– DO NOT charge battery
If There is Fast Flash Red Indication:
Confirm the battery being used with the WRSM is listed in Table 5.1
and is good in condition.
Remove the battery and restart the Vehicular Charger.
If the symptom persist, please send the Vehicular Charger to the
nearest Service Center for further verification.
If There is No LED Indication:
Check that the WRSM with battery or the battery is inserted
correctly in the pocket.
Make sure that the CLA adapter is plugged into a CLA power
source and the LED on the CLA adapter is on.
Confirm that the battery being used with the WRSM is listed in
Table 5.1 .