Vinotemp 400 Assembly Instructions

BEFORE PROCEEDING, PLEASE READ ALL INSTRUCTIONS FIRST!
The tools required for disassembly and reassembly of your custom Winecellar are as follows:
A) 7/16 Wrench
B) Phillips Head Screwdriver
C) Metric
D) 1/4" Nut Driver
You will need a clean level area. It will be necessary for 2 or
complete the following instructions:
1. Remove shipping carton and packing material with exception to pallet. Open door
and
remove the plastic bag containing four or six casters depending on the size of
unit.
2. Place the cardboard on ground behind winecellar.
3. With the 7/16" wrench, remove the two baits at the top of cooling unit. Carefully
slide the unit out and place it on the ground out of the way in an upright position,
being careful not to damage the insulated bottom.
4. If you have a model 700, remove the middle
back brace, then remove screws on top
Carefully remove the screws that are on the cabinet side of the hinge making sure
5.
someone is holding the door while screws
cardboard to the side of winecellar.
6. With the Phillips Head Screwdriver or 1/4" Nut Driver carefully remove the
screws holding the bottle racks, be sure to save the screws which
the top back of rack. Remove entire rack. (Standard cellar trellis racks)
Note:
bar
the

Removal of E-Line (Black Metal) Racks:

Disassemble/Assemble instructions

FOR YOUR PERSONAL WINECELLAR
4mm
Hex Wrench
Models with horizontal support
must be removed prior to removing rack.
-Remove the cellar trellis row sticks from the top of rack.
people to help in disassembly to
3
bar
by removing center screw in
and
bottom of middle bar.
are
being removed. Place the door on
bar
(single door 440
are
located in
and
single door 400),