Ipgsm-4Gc Trouble Detection Information; Ipgsm-4Gc Specifications - Honeywell IPGSM-4GC Installation And Setup Manual

IPGSM-4GC Commercial Fire Communicator – Installation and Setup Guide

IPGSM-4GC Trouble Detection Information

Telco 1 is used for the Fire Panel to output contact ID messages to the IPGSM-4GC, and Telco 2 is used by the IPGSM-
4GC to report faults to the Fire Panel. If Telco 1 is not operational, the Fire Panel will use Telco 2 to report events if
there are no faults in the Communicator.
Fault Condition
PowerBoost1 fault
Communicator fault
 Failure of the communications path when
IP only or GSM only is programmed as a
communications path.
 Failure of both communications paths
when IP&GSM is programmed as a
communications path.
Dialer Capture Module buffer is full.

IPGSM-4GC Specifications

ITEM
Cabinet Dimensions:
Transformer: 1451-UL9
Battery:
Battery Charging Current:
Battery Discharge Current:
Environment:
Supervision:
Indication to Fire Panel
Telco 2 is cut.
Telco 2 is cut.
Telco 1 and 2 are cut.
Hang up. (Panel will retry, giving the buffer a chance
to empty.)
SPECIFICATION
Width 12 3/4 inches, Height 14 7/8 inches, Depth 3 inches
Primary – 120VAC, 60Hz, 850mA, Secondary – 18VAC, 72VA
12V, 7Ah sealed lead acid type (not supplied)
Use a Honeywell 712BNP, Yuasa NP7-12 or equivalent.
maximum 1A
standby 230mA, active 950mA
Operating temperature: –20º to +55ºC, for ULC installations 0ºC to
+49ºC
Storage temperature: –40º to +70ºC
Humidity: 0 to 95% relative humidity, non-condensing, for ULC
installations 0% to 93%
Altitude: to 10,000 ft. operating, to 40,000 ft. storage
The Radio (communicator), battery, and AC power, conditions are
monitored by the cabinet indicator LEDs:
RADIO TROUBLE lights when any of these conditions exist.
Both IP and GSM communication paths are lost.

Communicator radio is not registered.

Old Alarm Time has been exceeded. (Message has not been

delivered within the fixed 10 minute window.)
LOW BATTERY lights when the battery voltage is less than 11.5VDC.
AC LOSS lights when the AC power is less than 90VAC.
– 13 –