Interim Spin - Miele WWG 660 Operating Instructions Manual

Omitting the final spin (Rinse
hold)
 Set the spin speed to  (Rinse
hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps to prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
Ending a programme with a spin
cycle
The display shows 
alternately with the ideal spin speed.
 Touch the Start/Add laundry sensor
control to start the final spin.
Ending a programme without a spin
cycle
 Reduce the spin speed to
 Touch the flashing Start/Add laundry
sensor control.
Rinse hold
0 .

Interim spin

There is a spin cycle after the main
wash and between the rinses. A
reduction in the final spin speed will
also reduce the interim spin speed as
appropriate.
Omitting the interim-spin and
the final spin
 Before the start of the wash
programme, reduce the spin speed to
.
0
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.
Spinning
41