Advertisement
Quick Links
HOW TO FIT
YOUR TIPPERARY HELMET
WHAT YOU NEED
• A soft fabric measuring tape with inches or centimeters.
Don't have one? You can download and make your own
All you need is some scissors and clear tape.
HOW TO MEASURE
Place the tape measure snugly around your head at the
widest point which is about 1" or 2.5 cm above your
eyebrows. Make sure the tape goes over the bump
at the back of yourhead and that it is just above the
top of your ears.
Take that measurement and refer to the size chart
for the helmet of your choice:
here.
Advertisement
Summary of Contents for Tipperary Sportage
- Page 1 HOW TO FIT YOUR TIPPERARY HELMET WHAT YOU NEED • A soft fabric measuring tape with inches or centimeters. Don’t have one? You can download and make your own here. All you need is some scissors and clear tape. HOW TO MEASURE Place the tape measure snugly around your head at the widest point which is about 1” or 2.5 cm above your eyebrows. Make sure the tape goes over the bump at the back of yourhead and that it is just above the top of your ears. Take that measurement and refer to the size chart for the helmet of your choice:...
- Page 2 HOW TO FIT YOUR TIPPERARY HELMET OVERALL FIT CHECK THE BRIM A correct fit is one that is snug and comfortable, The brim should not be more than two finger’s width but not loose. With a proper fit there will not be any above your eyebrows. If it is any lower it may block excessive up and down rocking movements. If the fit your vision. is too tight, it will not be comfortable. SIZING PADS CHIN STRAP When you first put on your helmet make sure the The harness must be comfortable around your ears. thicker rear pad is in place at the back of the helmet. Lengthen or shorten the strap by sliding the adjusting Check the fit. If it is too snug, remove the thicker rear buckle. The chin strap should fit snugly. It needs pad and replace with the thinner rear pad. Check the to be tight enought to hold your helmet in place but fit. If additional padding is required to snug the fit, not so tight that it is uncomfortable or you feel like you use the padding supplied. You my need to cut this cannot swallow. additional padding to help the helmet fit correctly. To tighten or loosen the chin strap: For the Sportage and Sportage Toddler, insert the • Remove the chin strap cover pading under the rim liner. For the Sportage Hybrid, •...
Need help?
Do you have a question about the Sportage and is the answer not in the manual?
Questions and answers