Main Power And Energy Saver Key; How To Turn On The Main Power - Canon imageRUNNER ADVANCE C350P Starter Manual

Main Power and Energy Saver Key

This section describes how to use the main power switch and the Energy Saver key.

How to Turn ON the Main Power

Make sure that the power plug is firmly inserted into the
power outlet.
WARNING
Do not connect or disconnect the power cord with
wet hands, as this may result in electrical shock.
IMPORTANT
If you want to turn OFF the main power and then back
ON again, wait for at least 10 seconds after the main
power indicator is turned OFF before turning ON the
main power. However, when [Quick Startup Settings
for Main Power] is enabled, if you do not wait more
than 20 seconds after the main power indicator is
turned OFF, quick startup is not performed.
01
Press the switch to the "I" side to turn
the main power ON.
The main power indicator on the control panel lights
when you turn ON the main power switch.
Various screens appear when system software is
loading.
If you are using a login service, log in using the
procedure for the login service you are using.
32

Main Power and Energy Saver Key

NOTE
You can change the default display that appears
)
after the machine is turned ON from [Default
Screen after Startup/Restoration] on the Settings/
Registration screen. (See e-Manual > Settings/
Registration.)
If this machine is connected to a powered off Mac
)
computer by USB cable, the computer may turn on
automatically when this machine does. In this case,
disconnect the USB cable from the machine. You
may also be able to solve this problem by using a
USB hub between the machine and the Macintosh.
The response of the buttons and keys may not be
)
optimal immediately after you turn ON the main
power of the Mac.
If you set [Quick Startup Settings for Main Power]
)
to 'On' in [Preferences] (Settings/Registration), the
tone sounds when turning ON the main power of
the machine. (Depending on the situations, the
machine does not startup quickly and the tone
does not sound.)
Depending on the conditions under which the
)
machine is being used, the machine may not
startup quickly if you set [Quick Startup Settings
for Main Power] to 'On' . For more information, see
e-Manual > Settings/Registration.
If you are using Department ID Management, see
)
e-Manual > Basic Operations.
1
If you are using SSO-H, see e-Manual > Basic
)
Operations.
2