Download Print this page

Makita ADP10 Instruction Manual page 4

Interchangeable adapter
Hide thumbs

Advertisement

16. Do not attempt to use a step-up transformer,
an engine generator or DC power receptacle.
17. Do not allow anything to cover or clog the
charger vents.
18. Do not plug or unplug the cord and insert
or remove the battery and adapter with wet
hands.
19. Never use gasoline, benzine, thinner, alcohol
or the like to clean this adapter. Discoloration,
deformation or cracks may result.
Charging
CAUTION:
Follow the steps instructed in this
manual. If you insert the battery with the adapter to
the charger mounted on the wall, the battery or the
adapter may come off and fall off.
1.
Plug the battery charger into the proper AC volt-
age source.
2.
Insert the adapter into charger until it stops adjust-
ing to the guide of charger.
3.
Insert the battery cartridge to the adapter.
Makita Europe N.V.
Makita Corporation
www.makita.com
4.
When the battery cartridge is inserted fully,
charging will begin.
5.
After charging, remove the battery cartridge from
the adapter while sliding the button on the battery
cartridge.
6.
Remove the adapter from the charger while slid-
ing the button on the adapter. Then unplug the
charger.
NOTICE:
This adapter is for charging Makita
battery cartridge. Never use it for other purposes
or for other manufacturer's batteries.
NOTE: The terminal cover of the charger opens as
you insert the adapter and closes as you pull out the
adapter.
The terminal cover of the adapter also opens as you
insert the battery cartridge and closes as you pull out
the battery cartridge.
NOTE: The pattern of the indicator lamps is varies
depending on the charger.
Refer the instruction manual of the charger to check
the status of charging.
Jan-Baptist Vinkstraat 2,
3070 Kortenberg, Belgium
3-11-8, Sumiyoshi-cho,
Anjo, Aichi 446-8502 Japan
885759-224
EN
20190529

Advertisement

loading

  Also See for Makita ADP10

  Related Manuals for Makita ADP10