Video Products VGA-CMP Installation Manual

VPI
VIDEO
PRODUCTS
INCORPORATED
INSTALLATION GUIDE FOR THE
VGA-CMP
INTRODUCTION
The VPI VGA-CMP converts VGA video to component video.
INSTALLATION
1. Turn OFF power to video source and video display device.
2. Connect a VEXT-3-MM VGA video cable (sold separately) from the video source to the female connector labeled "VGA" on
the VGA-CMP.
3. Connect a set of CMPEXT-3-MM 75 ohm RCA cables (sold separately) between the "Y", "Pb", and "Pr" connectors on the
VGA-CMP and the like connectors on the video display device.
blue, and the "Pr" connector is red.
4. Plug in the AC adapter and connect it to the VGA-CMP.
5. Turn ON power to the video source and video display device.
Note: Additional video cable lengths (VEXT-6/10/15/25/35/50/75/100-MM and CMPEXT-6/12/25/50/75/100-MM) may be
ordered from Video Products Inc by calling (800) 626--7801 (U.S) or 330-562-2622 or visit our website at www.vpi.us
VEXT-xx-MM
(sold separately)
CPU
VGA Video
15HD Female
Connector
Left End View of VGA-CMP
Aurora,Ohio 44202
1275 Danner Drive
Tel: 1-800-626-7801
Fax: 330-562-1999
www.vpi.us
VGA-CMP
9 VDC
Adapter
9VDC Adapter
ADAPTER
(supplied)
Power
Connector
Typically the "Y" connector is green, the "Pb" connector is
VGA-CMP
nc VPI I Products Video
CMPEXT-xx-MM
(sold separately)
Right End View of VGA-CMP
HDTV
w/ component
video
Component Video
75 Ohm RCA
Connectors