DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM
4.
Set the casing on wood blocks with the pump cavity
facing up. Using a mallet, tap the shaft assembly
(1) into place until the bearing is seated against the
shoulder. Secure the shaft using a retaining ring (2).
Place the double spring assembly (3) inside the
pump. Set the swash plate pivot (4) onto the spring
assembly.
5.
Position the swash plate (1) as shown. Press down
on the needle bearings (2), until they click into place.
6.
Set the cone (1) on the pins (2) of the cylinder block
with the flat side down.
2 4/7/2006
A.10.A / 63
4
20013876
5
20013877
6
20013868