VPI SE-SV-2-LC Installation Manual

S-video switch

Advertisement

VPI
VIDEO
PRODUCTS
INCORPORATED
INSTALLATION GUIDE FOR THE
SE-SV-2-LC

INTRODUCTION

The SE-SV-2-LC S-Video Switch allows two S-Video sources to be switched between a single S-video display.
sources such as a PC, DVD player, satellite receiver, or VCR to name a few. With 150 MHz bandwidth, the SE-SV-2-LC supports standard S-
video resolution–up to 800 x 600.

INSTALLATION

1.
Turn OFF power to sources and display.
2.
Connect the SVEXT-3-MM S-video cable (supplied) from the display to the female connector labeled "S-VIDEO OUT" on the SE-SV-2-LC.
3.
Install one male end of another SVEXT-x-MM cable (not supplied) into a source's S-video output connector.
4.
Install the other male end of the same SVEXT-x-MM cable into the female connector labeled "S-VIDEO IN 1" on the SE-SV-2-LC.
5.
An additional S-video source may be plugged into the remaining female connector labeled "S-VIDEO IN 2" as required.
6.
Plug in the AC adapter and connect it to the SE-SV-2-LC.
7.
Turn ON power to the sources and display.
Note: Additional S-video cable lengths (SVEXT-xx-MM where xx is the length of the cable in feet) may be ordered from Video Products
Inc by calling (800) 626-7801 (U.S) or 330-562-7070 or visit our website at www.vpi.us.
PC, DVD, Satellite,
or VCR
PC, DVD, Satellite,
or VCR
Left End View of SE-SV-2-LC

OPERATION

Press the select button to switch between connected S-video sources.
Aurora,Ohio 44202
1275 Danner Drive
Tel: 330-562-7070
Fax: 330-562-1999
www.vpi.us
S-Video Cable
(not supplied)
S-Video Cable
(not supplied)
VPI
R
Vi deo Products Inc
SE-SV-2-LC
Top View of SE-SV-2-LC
Right End View of SE-SV-2-LC
The S-video may come from
AC Adapter
(supplied)
SVEXT-3-MM
(supplied)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SE-SV-2-LC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for VPI SE-SV-2-LC

  • Page 1 The SE-SV-2-LC S-Video Switch allows two S-Video sources to be switched between a single S-video display. sources such as a PC, DVD player, satellite receiver, or VCR to name a few. With 150 MHz bandwidth, the SE-SV-2-LC supports standard S- video resolution–up to 800 x 600.
  • Page 2 Products Inc, 1275 Danner Drive • Aurora, OH 44202. CHANGES The material in this guide is for information only and is subject to change without notice. Video Products Inc reserved the right to make changes in the product design without reservation and without notification to its users.

Table of Contents