Table of Contents
Advertisement
ENGINE STORAGE
IMPORTANT: This service should be performed by
an Authorized PCM Premier dealer.
CAUTION
Refer to FLUSHING COOLING SYSTEM before
proceeding.
1. Fill the fuel tanks with gasoline and add a
sufficient amount of gasoline stabilizer, such
as STA-BIL™ fuel stabilizer, to prevent the
formation of fuel gum and varnish. Follow the
instructions on the container.
WARNING
On fuel injected engines, you MUST bleed off fuel
pressure before proceeding. Failure to do so
may cause personal injury.
2. Remove, empty and clean the fuel filter
assembly. Reinstall with a new fuel filter and
gasket / seals. Refer to Engine Maintenance for
filter replacement procedures.
NOTE: DO NOT re-use old fuel filter components.
Always replace with new fuel filter element and gasket /
seals.
WARNING
Accumulation of water and other fuel
contaminants may form corrosive compounds
that can damage the fuel filter, and result in fuel
leakage. Ethanol blended fuel may increase this
risk. For this reason, annual replacement of the
fuel filter, at a minimum, is required to avoid risk
of explosion or fire.
WARNING
Operate the bilge blower and be sure no fuel vapors
are present when treating the engine. Be sure the
engine compartment is well-ventilated to prevent a
potential fire hazard.
3. Run the engine and allow it to reach normal
operating temperature (a minimum of 10
minutes). Shut down the engine and change the
oil and oil filter (See ENGINE MAINTENANCE).
4. Flush the cooling system if operating in salt
water or brackish water areas. (See ENGINE
MAINTENANCE).
OUT-OF-SEASON STORAGE - 13
Operate the bilge blower and be sure no fuel vapors
are present when treating the engine. Be sure the
engine compartment is well-ventilated to prevent a
potential fire hazard.
5. Restart the engine and allow it to idle for 5
minutes.
.
6. Turn off the ignition. If fogging the engine is
required for extended storage, remove the spark
plugs. Use an aerosol-type fogging solution and
spray a sufficient amount of oil into each cylinder
spark plug hole. (Follow the instructions for the
storage oil used.) Turn the crankshaft several
revolutions by hand to spread the oil evenly
throughout the cylinders.
Install the spark plugs and connect the spark
plug wires.
Excess storage oil in the engine's cylinders can
cause hydrostatic locking to occur, and severe
damage to the engine.
7. Remove and clean the flame arrestor and
the vent hoses, and reinstall on the engine.
Cover the throttle body assembly ,to prevent
the possibility of the water entering the engine
through the throttle body assembly, during
storage.
8. Close the fuel shut-off valve (if equipped).
L510010D-17
WARNING
CAUTION
49
Advertisement
Table of Contents
