Coating Function
Coating Preprinted Paper
The following is an explanation of the basic procedure for coating preprinted paper. For more detailed procedures, see
the references to other guides.
Preparations
Coating Features screen
Press [Coating] to switch to the Coating
Features screen.
For more information, see Chapter 1,
"Introduction to the Coating Functions," in the
Coating Guide.
What You Can Do with This Machine
(Coating Features Screen)
To Coat Full Surface of Preprinted Paper
This mode enables you to coat the full surface of preprinted paper with the clear toner.
*
Each toner (black, cyan, magenta, or yellow) is not used, only the clear toner is used for this mode.
32
Load the Preprinted Paper
Loaded in the paper drawer
Load the preprinted paper.
You can also load the preprinted paper into
●
the stack bypass or paper deck-AA1.For more
information, see Chapter 1, "Loading Preprinted
Paper, " in the Coating Guide.
For instructions on specifying the Finishing
modes, see Chapter 1, "Collating Coated Paper
(Finishing)," in the Coating Guide.
For instructions on coating both sides of
preprinted paper, see Chapter 1, "Coating Both
Sides of Preprinted Paper (2-Sided)," in the
Coating Guide.
Coating Guide Chapter 2