CFM Louvre Kit - Black DV4136LK Installation Instructions

Louvre Kit - Black

Installation Instructions

Models: DV4136LK
The DV4136LK louvre kit is designed for use on
fireplace model DVB4136 (Item number GF__R6J2)
DVA4136 (Item number GFYN5J0).
Check Carton Contents
Compare shipping carton contents in Figure 1 with
actual parts received for the model trim kit purchased. If
any parts are missing or damaged, contact your dealer
before starting installation.
Contents
Installation Instructions
Hood
Bottom Louvre Assembly
Top Louvre Assembly
Bolt Bag: 5 screws, 2 pivot brackets, 2 clevis pins, 2
clips
Top Louvre
Screws
Fig. 1 Carton contents.
Installation Instructions
CAR229
louvre kit
1. Install the hood to the fireplace with three (3) screws
carton contents
provided. Align the slots on the hood with the holes
6/08
in the top opening of the fireplace and secure with
screws. (Fig. 2)
Cold Air Box
(3) #8 x 1/2 Sheet Metal Screws
Fig. 2 Install hood.
Hood
Bottom
Louvre
Pivot Brackets
Clip Pin
Clevis Pins
CAR229
Outer Top
Front
Hood
KT1022
KT1022
2. Remove the top lou-
vre assembly from
carton and install
in the top opening
of the fireplace just
below the newly
installed hood. The
hook of the louvre
fits into the brackets
as shown in Figure
3.
3. Install the two (2)
pivot brackets to the bottom of the fireplace and
secure with screws provided. (Fig. 4)
Basepan Front
Fig. 4 Place pivot brackets into basepan slot.
4. Install bottom louvre to pivot brackets using the
clevis pins provided. Slide the clip pins through the
holes in the clevis pins. (Fig. 5)
������
Installation complete.
������� ������
����
Install clip pins through
clevis pin
������
������� ������ ������
Fig. 5 Install bottom louvre.
����
������
������� ���� ���
1
2
Glass Panel
FP1854
Fig. 3 Install louvre.
FP1854
Install louvre
6/08
Tab
FP1855
Install bottom louvre
into brackets, se-
cure with clevis pin
KT1024
20014177 6/08 Rev. 1
Louvre