Installation Of Logs; Ember Material Placement; Lava Rock; Flame Adjustment - Vermont Castings DBR33 Installation Instructions & Homeowner's Manual

INSTALLATION OF LOGS

1 . Remove front glass. (See "Glass Removal" Section)
2. Remove logs from the packaging.
As with all plastics — these are not toys
and should be kept away from children and
infants.
3. Place rear log on rear bracket (ensure log is seated
properly, leveled and centered to the unit), so it will not
move from side to side and it is firmly positioned on the
bracket.
4. Place front left log on top of burner, left side. Use log's
bottom holes to locate it into the left bracket log locator
studs.
5. Place front right log on top of burner, right side. Use log's
bottom holes to locate it into the right bracket log locator
studs.
6. Place ember material on top of burner. (See "Ember
Material Placement" Section).
7. Place top left log onto locator notches. Ensure log is
secure.
8. Place top right log onto locator notches. Ensure log is
secure.
DBR33
BA5
Log Top Left
BA2
Log
Front
Left
DBR36
BB8
Log Top Left
Log Rear
BB6
Log Front Left
DBR39
Log Top Left
BC7
Log Rear
BC5
Log Front Left
BA6
Log Top Right
BA4
Log Rear
BA3
Log Front
Right
Fig. 42
BB9
BB10
Log Top Right
BB7
Log Front Right
BC8
BC9
Log Top Right
BC6
Log Front
Right
Fig. 44
LOGS
Front Left Log
Front Right Log
Rear Log
Top Left Log
Top Right Log

EMBER MATERIAL PLACEMENT

Separate the ember material into small pieces, roughly
1/2" in diameter and place onto the burner in front of the
front logs. Do NOT pack down, leave in fluffy, loose
condition for most realistic ember effect.
The lava rock provided with this fireplace must be
placed on the firebox base on either side of the burner
assembly.
For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
knob located near the centre of the gas control. Fig. 46a
and 46b.
Fig. 43
- 19 -
DBR33
BA2
BA3
BA4
BA5
BA6
Top logs must be placed properly onto
notches.

LAVA ROCK

Under no circumstances should this lava
rock be placed on any part of the burner
assembly.

FLAME ADJUSTMENT

DBR36 DBR39
BB6 BC5
BB7 BC6
BB8 BC7
BB9 BC8
BB10 BC9
Fig. 46a
Fig. 46b