Ozobot Bit Getting Started page 2

Ozobot Tips
Tips: Calibration
1 2
Hold down the power button on
Quickly Place Ozobot in the middle of
Ozobot for 2 seconds until the
the black calibration dot.
LED light turns white.
3
X
Ozobot will move forward and blink green,
which means it has successfully calibrated.
Start over if Ozobot blinks red.
Use this black dot to calibrate.
Tips: Drawing Lines
Too Thin! Too Thick! Inconsistent! Just Right Too Close! Just Right
Too Sharp! Just Right Just Right