Black & Decker Price Pfister Parisa 34-1N Manual page 5

16
16A
16B
16C
16 WATER SUPPLY LINES
Gently separate hot and cold supply tubes (16A 6A 6 ), approximately three inches
apart. Connect water Supply Lines (16C) to Faucet Inlets (16B). (Supply lines
and fi ttings are not included.)
17
17 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
FAUCET FUNCTIONS
18
CLOSED
HOT
18A A
COLD
18 VALVE FUNCTION
By lifting the Lever Handle (18A 18 ) up, the valve will be activated allowing water to
18A
fl ow. The water fl ow will increase by continuing to lift up the Lever Handle (18A
By rotating the Lever Handle (18A 18 ) counterclockwise, the water temperature
18A
will decreased to fully cold. By rotating the Lever Handle (18A
water temperature will increased to fully hot.
ENGLISH
16A A
16B
16C
OPEN
18A A
18 ). 18A
18 ) clockwise, the
18A
5
19
19A A
19 SPOUT FUNCTION
The Spout (19A 19 ) can be rotated around the Faucet Body in any direction.
19A
20
20B
20A 20A
20 SIDE SPRAY OPERATION
(For products with side spray). The Side Spray (20A) can be pulled forward
to spray water in any direction. To activate the Side Spray, press the Toggle
Button (20B) located on the back of the Side Spray (20A).
21
21A 21A
21E
21D
21C
21 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (21A). Turn Valve
(21B) on and allow both hot and cold water to run for at least one minute each.
While water is running, check for leaks. To clean the aerator, disassemble Aerator
Housing (21A) by separating the Aerator Shell (21C), Basket (21D), and Washer
(21E). Once parts have been cleaned, reassemble by reversing 21E). Once parts have been cleaned, reassemble by reversing
21E
20A 20A
21B
steps.