Download  Print this page

Kenwood Chef Instructions Manual page 12

Hide thumbs

Advertisement

To fit and use your
Splashguard
Splashguard
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the underside
of the mixer head
The hinged section should be positioned as
shown.
4 Insert required tool.
5 Lower the mixer head.
• During mixing, ingredients can be added
directly to the bowl via the hinged
section of the splashguard
• You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising the
mixer head and pushing it down.
Splashguard
The splashguard assembly consists of
2 pieces: the head shield
splashguard
.
• The splashguard cannot be fitted to the
bowl unless the shield is fitted.
1 Clip the head shield upwards onto the
underside of the mixer head
located.
2 Rest the splashguard on the bowl rim
and then slide forward until fully located
.
bl

until fully located.
8
.
9

and the
until fully
bk
Tool Adjustment
K-beater & Whisk
The tools are set to the correct height for
the bowl supplied in the factory and should
not require adjustment.
However, if you wish to adjust the tool use
a suitable sized spanner:
TYPE KVC51 = 15mm
TYPE KVL61 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
whisk and K-beater should be almost
touching the bottom of the bowl
4 Using a suitable spanner loosen the nut
sufficiently to allow adjustment of the
shaft
. To lower the tool closer to the
bn
bottom of the bowl, turn the shaft anti-
clockwise. To raise the tool away from
the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
acheived tighten the nut securely.
• Note: Spanner
illustration purpose only.
Dough Hook
This tool is set at the factory and should
require no adjustment.
8
bm
shown is for
bn
.

Advertisement

loading

  Also See for Kenwood Chef

This manual is also suitable for:

Chef xlKvc51Kvl61