Installation/Connection; Muting Upon The Reception Of A Phone Call - Kenwood KDC-230UI Instruction Manual

TROUBLESHOOTING
Symptom
• Sound cannot be heard • Reconnect the Android device.
during playback. • Launch any media player application on the Android
• Sound output only from
the Android device. • Relaunch the current media player application or use
• Restart the Android device.
• If this does not solve the problem, the connected
• If USB connection does not work, connect the Android
"NO DEVICE" or "READING" • Reconnect the Android device.
keeps flashing. • If USB connection does not work, connect the Android
Playback is intermittent or
sound skips.
"NO MUSIC"/"ANDROID • Make sure Android device contains playable audio files.
ERROR" • Reconnect the Android device.
• Restart the Android device.

Muting upon the reception of a phone call

Connect the MUTE wire to your telephone using a commercial
telephone accessory. (Page 19)
• When a call comes in, "CALL" appears. (The audio system pauses.)
– To continue listening to the audio system during a call, press B SRC.
"CALL" disappears and the audio system resumes.
• When the call ends, "CALL" disappears. (The audio system resumes.)
Remedy
device and start playback.
another media player application.
Android device is unable to route the audio signal to unit.
(Page 15)
device through auxiliary input jack.
device through auxiliary input jack.
Turn off the power saving mode on the Android device.

INSTALLATION/CONNECTION

Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that comes into
contact with metal parts to protect the wires.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Mount the unit at an angle of less than 30°.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on
and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
17
ENGLISH