Filter Maintenance - Husqvarna DC 6000 Workshop Manual

10
Filter
The filter is made of a polyester material and can be washed with water as necessary. Change filter after 500 hours or
after 6 months�
•In order to avoid destruction of the finish or ePTFE membrane clean the filter elements with a gentle soft jet of
water. A strong/sharp jet will destroy the ePTFE membrane. The cleaning can be supported by a soft brush.
•Wash the filter elements from top to bottom. Avoid rubbing or scrubbing on selected spots.
•Dry the filter elements carefully. Approximately one week at a temperature of 15-20 °C, or at 70 °C during 14 hours
in the oven. It is important that they are 100% dry.
•After washing in above mentioned way, the filter elements can be used again at low pressure drop. The life time after
washing is approximately 60-70 % of the life time in new condition.
1
3
5
7
30 30
SERVICE AND MAINTENANCE
2
4
6
8

Filter Maintenance

1� Remove the longopac holder.
2� Loosen the clamping brackets for
the lid to the filter container.
3� Loosen the handle by loosening
the knobs�
4� Grasp the lower rim of the filter
container and lift the container
out of its guide groove. The filter
container does not fall down but
rests on the handle.
5� Pull out the filter. Clean and dry
the filter or fit a new one.
The filter is a conical shape and
the wider section should be at the
top of the filter container.
6� Replace the filter container in its
guide groove on the handle.
7� Tighten the container using the
clamping brackets and connect
the hose connector to the filter
container�
8� Insert the longopac holder.