Switching The Speaker Position Mode; Adjusting The Output Level Of The Speakers; Balance Setting - JVC TH-U1 Series Instructions Manual

Dvd digital cinema system
Hide thumbs Also See for TH-U1 Series:
Table of Contents

Advertisement

Basic operations
Switching the speaker
position mode
Switch the speaker position mode to "S. SPK R" only when
you connect optional speakers (see pages 7 and 8).
1
Press
AUDIO.
The system turns off.
2
Press and hold SETTING while
holding SHIFT.
The current setting appears on the display window.
3
Press SETTING while holding
SHIFT to select "S. SPK R".
• S. SPK F (Initial setting): For speaker layout
• S. SPK R: For speaker layout
you connect optional speakers and place the speakers
B
as layout
.
The adjustment display automatically disappears a few
seconds later with the current setting.
NOTE
• If you disconnect optional speakers and place the speakers as
speaker layout A, switch the speaker position mode to "S.
SPK F".
• As the speaker position mode is changed, the following
settings are also changed automatically:
– The output level settings of each speaker are initialized.
– The surround mode (see page 20) is set to "AUTO SUR".
Adjusting the output level of
the speakers
1
Press SPK-LEVEL to show the
target speaker indication on the
display window.
Each time you press the button, the indication of the
channel changes as follows:
7When the speaker position mode is "S. SPK F"
CENTER (Center channel sound of center surround
speaker) ZSURR (Surround channel sound of center
surround speaker) Z SUBWFR (Subwoofer) Z
(back to the beginning)
7 When the speaker position mode is "S. SPK R"
FRNT L (Front left speaker) Z FRNT R (Front right
speaker) Z CENTER (Center speaker) Z SURR L
(Surround left speaker) Z SURR R (Surround right
speaker) Z SUBWFR (Subwoofer) Z (back to the
beginning)
15
A
.
B
. Select this only when
See page 12 for button locations.
2
Press LEVEL +/– to adjust the
output level from –6 to 6.
NOTE
• When the speaker position mode is "S. SPK R", you can also
make adjustments by using the setup menu shown on the TV
screen. (See page 33.)
• These adjustments take effect for all sources.

Balance Setting

You can adjust the balance between the front left and front
right speakers.
NOTE
• This function also takes effect for the sources other than
DVD.
• Before you start the operation;
There is a time limit when doing the following steps. If the
setting is canceled before you finish, start from step 1 again.
1
Press SETTING while holding
SHIFT.
Example:
2
Press Cursor 3/2 to make an
adjustment or selection.
Example:
The adjustment display automatically disappears a few
seconds later with the current setting.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xv-thu1Sp-thu1wSp-thu1fSp-thu1c

Table of Contents