Advertisement
Do you have a question about the X Terminator XT Series and is the answer not in the manual?
Yea my XT4000D ON THE SPEAKER CONNECTERS IT SAID POSITIVES ON OUTSIDE TERMINALS AND NEGATIVE TERMINALS R THE TWO INSIDE CONNECTS
The US Amps XT4000D is designed to deliver its rated power at low impedances, specifically:- 1 x 200W RMS @ 4 Ohms - 1 x 450W RMS @ 2 Ohms - 1 x 1500W RMS @ 1 Ohm For optimal performance at 1 Ohm, which is its maximum rated output, the correct wiring configuration would be:- A dual 2 Ohm voice coil subwoofer wired in parallel - Or two single 2 Ohm subwoofers wired in parallel This results in a final load of 1 Ohm at the amplifier’s speaker terminals.
This answer is automatically generated
Need help?
Do you have a question about the X Terminator XT Series and is the answer not in the manual?
Questions and answers
Yea my XT4000D ON THE SPEAKER CONNECTERS IT SAID POSITIVES ON OUTSIDE TERMINALS AND NEGATIVE TERMINALS R THE TWO INSIDE CONNECTS
The US Amps XT4000D is designed to deliver its rated power at low impedances, specifically:
- 1 x 200W RMS @ 4 Ohms
- 1 x 450W RMS @ 2 Ohms
- 1 x 1500W RMS @ 1 Ohm
For optimal performance at 1 Ohm, which is its maximum rated output, the correct wiring configuration would be:
- A dual 2 Ohm voice coil subwoofer wired in parallel
- Or two single 2 Ohm subwoofers wired in parallel
This results in a final load of 1 Ohm at the amplifier’s speaker terminals.
This answer is automatically generated