Table of Contents
Advertisement
Setting Self Clean
To set self clean:
1. Be sure the oven is empty and all oven racks are
removed. Remove all items from the oven. Be sure
oven door is completely closed.
2. Press Self Clean and the default 3 hour clean time will
appear in the display. You may accept the default 3 hour
clean time by going to step 3, or choose a different
clean time by continuing to press Self Clean to select 2
hours or 4 hours. Once you have the desired clean time
selected proceed to Step 3.
3. Press START to activate Self Clean.
4. As soon as Self Clean becomes active, a motor driven
lock mechanism will begin locking the oven door auto-
matically. Do not attempt to open the oven door (allow
15 seconds for the lock mechanism to lock the oven).
Once the oven door has locked, CLEAN will appear in
the display indicating Self Clean has started.
CAUTION
Do not force the oven door open when self-clean is
active. This can damage the automatic door-locking
system.
When Self Clean is finished:
CAUTION
Use caution when opening the oven door after self
cleaning. The oven may still be very hot and can cause
burns. To avoid possible burns stand to the side of the
oven when opening the oven door to allow hot air or
steam to escape.
1. CLEAN message will turn off, and Hot will appear in
display window.
2. Once the oven has cooled down (about 1 hour) and Hot
is no longer displayed, the oven door may be opened.
3. When the oven interior has completely cooled, wipe
away any residue or powdered ash with a damp cloth or
paper towel.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3
hours and a start time of 9:00 o'clock:
1. Be sure the clock is set with the correct time of day, the
oven is empty, and all oven racks are removed. Be sure
oven door is completely closed.
2. Press Delay Start.
3. Using numeric keypad, enter 9 0 0.
4. Press START to accept
5. Press Self Clean.
6. Press START.
If it becomes necessary to stop Self Clean when active:
1. Press off.
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool.
3. Before restarting Self Clean, be sure to read important
notes below.
Important note:
•
If your clock is set with the (default) 12 hr display mode,
the Delay Start for a Self Clean can only be
programmed to start up to 11 hours and 59 minutes
after the time showing in the display (be sure to set the
clock to current time before programming a delay start).
To set a Delay Start Self Clean to begin 12 or more
hours (maximum is 23 hours and 59 minutes) after the
time of setting, be sure to first set the control in the 24
Hr display mode.
•
If Self Clean was active and then interrupted by a power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another Self Clean
cycle.
•
If the oven temperature was high enough when Self
Clean was interrupted the oven control may not allow
another Self Clean cycle to be set for up to 4 hours.
OVEN CONTROLS
33
Advertisement
Table of Contents
