Advertisement
USING THE BACKLIGHT
Press SNOOZE/LIGHT bar located on the top of the clock to activate the display backlight for 5 seconds. The backlight will stay
on for 5 seconds each time it is pressed.
USING THE SNOOZE
To use the snooze, press the SNOOZE/LIGHT bar when the alarm is sounding. The alarm will be silenced temporarily, but will
resume sounding after 5 minutes.
CARE OF YOUR CLOCK
1. Store the clock without batteries when not in use.
2. A soft cloth or paper towel may be used to clean your clock. Do not use corrosive cleanser or chemical solutions on the clock.
Keep the clock clean and dry to avoid any problems.
3. Avoid putting the clock in a highly humid environment such as poolside or in a bathroom.
4. Do not expose the clock to direct sunlight, extreme hot or cold temperatures.
Note: Please replace your alarm batteries if beep alarm volume is low or vibration alarm strength is weak.
IMPORTANT: Extended storage can cause batteries to leak and damage the unit. Leaky batteries should be
discarded immediately. Skin burns or other personal injury can result. Always dispose of batteries according to
federal, state and local regulations.
- Clean the battery contacts and also those of the device prior to battery installation.
- Remove batteries from equipment that is not to be used for an extended period of time.
- Remove used batteries promptly.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or recharge able (ni-cad, nimh, etc) batteries.
Model SPC562
Printed in China
Model SPC562
Advertisement
