Opening Your Player; Mainboard Connections - Panasonic DMP-BD60 Installation Manual

HD-MOD DMP-BD60/80 NB

Opening your player

First make sure that your player is disconnected from the mains before you even start opening
the player.
If you set the unit in front of you with the display towards you there are 3 screws at the back of
the player. Remove them using a Philips screwdriver.
Remove the two screws at both the left, and right side.
Remove the top cover, by gently lifting the back of the cover up, until it comes free.

Mainboard Connections

After removing the top cover, you will see the power supply board and the green mainboard.
All of the connections are made on this mainboard.
Stick the logic board with some double-sided tape onto the mainboard, and connect wires from
points C, P, N, K, GND and +3v3 to the corresponding points on the Logic Board.
BluRayMods.com ©2008-2009 Page - 2 -