Code Search Methods; Manual Code Search; Auto Code Search - RCA RCU600 User Manual

Code Search Methods

If your component's brand is not listed in the Code List or you have tried all the codes for your
brand and the remote does not operate your component, use one of the Code Search methods below—
Manual Code Search or Auto Code Search. Both Code Search methods search all of the codes since
your component's code may be listed under another brand in the Code List.
Note: The Code Search method may take a long time because the remote searches all of the codes in
its memory for the code that operates your component. Therefore, if your brand is listed in the
Code List, use the Direct Entry method described on pages 5-9.
CODE INDICATOR
SEARCH
(BLINK)
ON•OFF
ENTER
CODE INDICATOR
SEARCH
(BLINK)
ON•OFF
ENTER
10

Manual Code Search

LIGHT 1. Manually turn on the component you want the remote
2. Press and hold the CODE SEARCH key until the indicator
3. Press and release the component key that corresponds to the
4. Aim the remote at the component. Press the ON•OFF key
5. When the component turns off, press the ENTER key
(OFF)
6. Use the Code Retrieval section on the next page to identify

Auto Code Search

1. Turn on the component you want the remote to operate.
LIGHT
2. Press and hold the CODE SEARCH key until the indicator
3. Press and release the component key that corresponds to
4. Aim the remote at the component and press the ON•OFF
5. As soon as the component turns off, you must press the
(OFF)
6. Use Code Retrieval section on the next page to identify
to operate.
light illuminates. Then release the CODE SEARCH key.
component you want the remote to operate (TV, VCR, DVD,
DBS•SAT, CABLE, AUDIO). The indicator light blinks once
and then remains lit.
continuously until the component turns off.
Important: Because there are so many codes, you may have to
press the ON•OFF key many times—possibly up to 200 times.
to store the code.
the code for your component for future reference.
light illuminates. Then release the CODE SEARCH key.
the component you want the remote to operate (TV, VCR,
DVD, DBS·SAT, CABLE, AUDIO). The indicator light blinks
once and remains lit.
key once. The remote automatically sends every code for
the specified component one at a time, with the three-second
delay between each code. Keep the remote aimed at the
component throughout this process.
ENTER key immediately so the remote stores the correct
code. If you do not press the ENTER key within three seconds,
the remote sends the next code in the list, and you will have
to start over from step 2.
the code for your component for future reference.