Table of Contents
Advertisement
Generic Pioneer Charter OCAP.fm Page 17 Friday, July 20, 2007 1:28 PM
Locking Volume Control To One Mode (Global
Volume Lock)
1.
On the remote control, press and hold SET UP
until the last-selected device key blinks twice.
2.
Enter 9 9 3. The last-selected device key
blinks twice.
3.
Select a mode (e.g., TV or AUX) which you
want to use to control the volume. The
selected device key blinks twice.
Now, when you press VOL+, VOL-,or MUTE, the volume of
the selected device (e.g., TV) is controlled regardless of
mode.
PROGRAMMING CABLE ID LOCK
The C4000 and S4000 Remote Controls are locked at the
factory to operate your provider's set-top box. However,
if you have another brand or model of cable converter or
satellite service that you would like to control, then you'll
need to perform the following steps to unlock the ID
Lock, enter a new manufacturer's code, and lock the ID
Lock again.
1.
Turn on the set-top.
2.
On the remote control, press CBL (or STB)
once; it blinks once. Then press and hold SET
UP until the CBL (or STB) key blinks twice.
3.
Enter 9 8 2. The CBL (or STB) key blinks four
times, indicating ID Lock is unlocked.
4.
Perform the instructions under
"Programming Device Control" on page 10 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the cable ID Lock.
5.
On the remote control, press CBL (or STB)
once; it blinks once. Then press and hold SET
UP until the CBL (or STB) key blinks twice.
www.urcsupport.com
17
Hide quick links:
Advertisement
Table of Contents
