Download  Print this page

Universal LITEAIDE HE-100B Owner's Manual

Preassembled automatic security floodlights motion sensor security lighting systems
Hide thumbs
   

Advertisement

OWNER'S
MANUAL
PREASSEMBLED AUTOMATIC
SECURITY FLOODLIGHTS
MOTION SENSOR SECURITY
LIGHTING SYSTEMS
LiteAide
®
HE-100B
HE-100BW
HE-112
HE-112W
HE-117
HE-117W
HE-117-2B

Advertisement

loading

  Related Manuals for Universal LITEAIDE HE-100B

No related manuals

  Summary of Contents for Universal LITEAIDE HE-100B

  • Page 1 OWNER'S MANUAL PREASSEMBLED AUTOMATIC SECURITY FLOODLIGHTS MOTION SENSOR SECURITY LIGHTING SYSTEMS LiteAide ® HE-100B HE-100BW HE-112 HE-112W HE-117 HE-117W HE-117-2B...
  • Page 2 OWNER'S MANUAL FLOOD LAMPS (BULBS) Your security floodlight uses two 150 watt (maximum) incandescent, quartz or halogen flood lamps. if you are replacing an old floodlight installation, save the flood lamps. If you are making a new installation, obtain two flood lamps from your local hardware store or home center.
  • Page 3 CAUTION Never allow sunlight to shine directly into the security floodlight sensor prior to, during or after installation. Direct sunlight could damage the sensor. 2. Remove the preassembled security floodlight from the box. Locate shield slots and push down over four retainer pins.
  • Page 4 Connect the security floodlight only to 110-120 volt, 60 Hertz electrical power. sufficient voltage and current to harm you if you come into contact with the 110-120 volt, 60 Hertz electrical power. 1. Turn off all electrical power to the old floodlight as follows: WARNING Ensure that the 110-120 volt, 60...
  • Page 5: Adjustments And Testing

    WHITE BARE GREEN (IF SUPPLIED) 4. With the gasket in place against the cover, place two mounting screws through the security floodlight cover and through the gasket. 5. Tuck wires into the electrical box and start the screws into the electrical box. Inspect to ensure that all wires are inside of the box (not pinched) and the gasket is in place.
  • Page 6: Timing Adjustment

    3. After the correct position has been established, tighten the elbow joint screw and the sensor head locknut at the end of the elbow (near the cover). Screw the lamps into the sockets. Walk Test Testing can be performed during daylight. Testing includes applying electrical power, walking into the sensing area to determine if the sensor head is aimed properly and...
  • Page 7: Final Adjustments

    The floodlight remains on the set time between 5 seconds and 18 minutes (approximate). The manual mode permits you to turn the security floodlight on for as long a time period as you desire. You end the on-time by manually turning the security floodlight off and then back on after 5 seconds (the security floodlight is now in the automatic mode).
  • Page 8: Limited 5 Year Warranty

    (5) years from the date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal residential use and service. If this product is found to be defective, Universal's only obligation, and your exclusive remedy, is the repair or replacement of the product, at Universal's discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alternation, neglect or mishandling.

This manual is also suitable for:

Liteaide he-112Liteaide he-100bwLiteaide he-112wLiteaide he-117Liteaide he-117-2bLiteaide he-117w