Troubleshooting; Declaration Of Conformity - Sealey Sac9000 Instructions Manual

7. TROUBLESHOOTING

PROBLEM
Unit does not work.
Unit cuts out.
In cooling mode no cool air is
coming out of unit.
No cool air coming out in
dehumidifying mode.
No hot air coming out in heating
mode.
Error code 'E2' appears at bottom
of display panel on unit.
Error code 'E3' appears at bottom
of display panel on unit.
Error code 'E4' appears at bottom
of display panel on unit.

Declaration of Conformity

following standards and directives. The construction file for this product is held by the Manufacturer and may be inspected, by a
national authority, upon request to Jack Sealey Ltd.
Air Conditioner, Humidifier, Heater Unit.
Model No: SAC9000
72/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC Marking Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and
component parts without prior notice. IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy
of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
POSSIBLE CAUSES
Power supply fault:
1. Not plugged in.
2. Damaged plug or socket.
3. Internal fuse blown.
1. Timer is set or room
temperature is lower than the
temperature set on the unit.
1. Room temperature is lower
than the set temperature.
2. There is frost on the evaporator.
1. Remove filter. If you can see
frost on the on the surface of
the evaporator then the unit is
defrosting.
1. Room temperature is higher
than the set temperature.
1. Failure of room temperature
sensor.
2. Evaporator low temperature
protector is damaged
3. Water storage tank is full.
We, the sole importer into the UK, declare that the product listed here is in conformity with the
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
SOLUTIONS
1. Plug unit into mains socket.
2. Replace plug as directed in
3. Return unit to dealer to
1. Set timer to 0.00 or wait for unit
1. Set temp. lower or wait for unit
2. The unit is defrosting and will
1. The unit will run again
1. Set temp. higher or wait for unit
1. Return unit to dealer for temp.
2. Return unit to dealer for temp.
3. Drain water tank and/or set up
Signed by Steve Buckle
For Jack Sealey Ltd. Sole importer into the UK of
Sealey Power Products.
01284 757500
Web address: www.sealey.co.uk
01284 703534
Section 1.1.9.
find cause and replace fuse.
to start automatically when
room temperature has risen.
to start automatically when
room temperature has risen.
run again automatically when
the process is finished.
automatically when the
defrosting process is finished.
to start automatically when
room temperature has fallen.
sensor replacement.
protector replacement.
continuous drainage.
24th November 2006
E-mail: sales@sealey.co.uk
SAC9000 - 1 - 241106