United States Stove Hearth Focus 6039HF Owner's Manual

Corn & pellet multifuel stove

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Hearth Focus

CORN & PELLET MULTIFUEL STOVE

Installation - Operation - Maintenance Instructions - Repair Parts

READ THIS ENTIRE MANUAL, THOROUGHLY, BEFORE ATTEMPTING TO INSTALL AND/OR

BURN YOUR NEW HEARTH FOCUS CORN AND PELLET MULTI-FUEL STOVE. FAILURE TO FOL-

LOW THESE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURIES OR

Safety Notice: If this stove is not properly installed, a house fire may result.

For your safety, follow the installation directions. Contact local building or fire officials

about restrictions and installation requirements peculiar to your area. Do Not Plug

this appliance into an electrical outlet before reading and understanding all operations

and always unplug the unit before attempting any work or maintenance. Do not

connect this stove to any chimney flue already serving another appliance. Carefully

observe and maintain all clearances to combustibles.

A note about fuel: Use only dried shelled corn with a moisture content of 14%

or less (11 to 12% provides the best results); any pellet fuel used should have

an ash content of 1% or less. If not, efficiency will suffer, and your warranty may be

voided.

Your Hearth Focus Corn/Pellet Stove operates on a negative pressure. Therefore, all

venting connections (elbows, T-pipe) must be sealed and airtight.

Use Hi-Temp silicone at each joint or connection.

UNITED STATES STOVE COMPANY GRANTS NO WARRANTY, IMPLIED OR STATED,

FOR THE INSTALLATION OR MAINTENANCE OF THE STOVE AND ASSUMES NO

RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).

UNITED STATES STOVE COMPANY - 227 INDUSTRIAL PARK ROAD-SOUTH PITTSBURG, TN. 37380

USSC

North

OWNER'S MANUAL

SAVE THESE INSTRUCTIONS

TECHNICAL ASSISTANCE (423) 837-2100 - (423) 837-2109 FAX

K e e p i n g

America

W arm

America

Since 1869

6039HF

EVEN DEATH.

arm

851672

Table of Contents

Summary of Contents for United States Stove Hearth Focus 6039HF

Page 1 UNITED STATES STOVE COMPANY GRANTS NO WARRANTY, IMPLIED OR STATED, FOR THE INSTALLATION OR MAINTENANCE OF THE STOVE AND ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S). UNITED STATES STOVE COMPANY - 227 INDUSTRIAL PARK ROAD-SOUTH PITTSBURG, TN. 37380 TECHNICAL ASSISTANCE (423) 837-2100 - (423) 837-2109 FAX USSC...
Page 2: Specifications
We strongly suggest installing smoke detectors in your home if not already installed. Initial burn off may cause slight smoke and odor the first few hours of operation. United States Stove Company Stove) reserves the right to alter products, specifications and price without notice.
Page 3 5. After all bolts and screws have been tightened properly, set the heater back up on the legs and replace the two ash dump covers. (See pg. 15 for ash dump cover placement) USSC 6039HF ASSEMBLY 1. The Auger is packed in the hopper and must be installed properly as illustrated below.
Page 4: Safety Steps
IMPORTANT: Proper installation of this stove is necessary for safe and efficient operation. Installing this product improperly may result in a house fire and personal injury. All applicable building codes for your location must be followed. In areas where building codes require additional steps to the installation of this product not included in this manual the building codes will take precedent and must be followed.
Page 5: Installation Requirements
BURNING SOLID FUELS SHELLED CORN • Corn must contain less than 14% moisture content. Wet corn will rapidly deteriorate stove components, reduce efficiency and void all warranties. Purchase a moisture tester if in doubt. • Corn must be clean and free from debris. Never burn corn right from the field. Damage caused by dirty corn is not covered by the product warranty.
Page 6: Clearances To Combustibles
CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access the electrical panel is (6) six inches (152mm).
Page 7: Guidelines For Exhaust Venting Systems Design
GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN It is recommended that only an authorized installer install your pellet/corn stove, preferably an NFI certified specialist. The following installation guidelines must be followed to ensure conformity with both the safety listing of this stove and to local building codes.
Page 8 DESIGN GUIDELINES FOR OUTSIDE COMBUSTION AIR CONNECTION For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air.
Page 9: Installation Configurations
Note: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA -B365 The Hearth Focus Corn/Pellet Stove Model 6039HF may be installed as follows: 1) A freestanding unit MOBILE HOME INSTALLATION REQUIREMENTS...
Page 10 Note: Always check dimensions on unit before cutting hole in wall 3’ Minimum Vertical Pipe 6039HF COMBUSTION EXHAUST OUTLET 10 1/16 AIR INTAKE 3' DIA 1 7/8" DIA 11 5/8 Dimensional tolerance ±0.25” USSC...
Page 11 THROUGH THE WALL, VERTICAL PIPE INSTALLATION WITH TERMINATION CAP The Hearth Pad is not required under the unit if the floor is noncombustible but is required 6 inches (152mm) beyond the front of the unit and 6 inches (152mm) beyond each side of the door if the floor is a combustble floor. wood flooring, carpet, linoleum, etc.
Page 12: Cleaning The Glass
GLASS MAINTENANCE, REMOVAL AND REPLACEMENT Your Hearth Focus Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (2) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and lift off of hinges.
Page 13: Understanding The Control Board
UNDERSTANDING THE CONTROL BOARD CONTROL PANEL Turning the heater OFF/ON, as well as adjustments for the fuel feed rate and room fan speed are performed by pressing the appropriate button(s) on the control panel which is located on the lower left-hand side of your Hearth Focus heater.
Page 14: Lighting Instructions
LIGHTING INSTRUCTIONS CAUTION: DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS. Before lighting your Hearth Focus for the first time, make sure that all items are out of the hopper, ash pan and firebox area.
Page 15: Disposal Of Ashes
Disposal of Ashes Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have been thoroughly cooled.
Page 16: Automatic Safety Features
Weekly Maintenance • Shut down the stove as directed in the operating instructions. Allow the stove to cool to room temperature. Remove the small clean-out slides in the lower corners of the firebox. Tap the sides of the burn chamber with a wooden stick. Do not tap the firewall behind the burn box as it may damage the insulation.
Page 17: Circuit Board Functions
CIRCUIT BOARD FUNCTIONS Once the control panel is turned to on, a timer begins that will start, stop and continue operation of the Hearth COMPONENT Exhaust Blower Agitator Auger Room Fan Automatic Shutdown Normal Operation Once the Hearth Focus has reached the normal operating temperature and switched to the “OFF” position, the unit will continue to operate on a much lower setting for 10 minutes.
Page 18: Error Codes And Display Indicators
ERROR CODES and DISPLAY INDICATORS CAUTION: When performing any internal electrical maintenance • Moving parts inside of the cabinet may cause injury. Do not operate unit with panels removed or open. • HOT parts. Do not operate the unit with panel open. •...
Page 19: Troubleshooting
Unplug stove before performing any maintenance PROBLEM ? Fire burns with a lazy, orange flame and/or fuel builds up in the firepot. Glass may become dirty. ? Fire goes out or stove shuts down. Fuel may stop feeding. ? Fire goes out or stove shuts down. Fuel may stop feeding.
Page 20: Wiring Diagram
WIRING DIAGRAM USSC...
Page 21 REPAIR PARTS DIAGRAM-6039HF USSC...
Page 22: Repair Parts List
88121 88122 891224 891223 891225 891226 25425MB 891331 891135 891137 REPAIR PARTS LIST-6039HF DESCRIPTION Feed Door Assembly Latch, Door Leg, Cast Iron Ash Pan Weldment (6039) Left Side Weldment Cabinet Side, Right Cabinet Back Support Frame (Back/Left) Support Frame (Back/Right)
Page 23 Part No. Descritption 25491 Feed Door 25492 Handle, Door 83506 Roll Pin, 3/8 x 1-1/4 88112 Gasket, 1/2” Sq. Rope 88087 Gasket, Glass (1 x 3/16) 891131 Glass Ceramic USSC Parts Diagrams and Parts Lists Qty. Part No. 83278 25465 25464 5 ft 83202...
Page 24 WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION AS SHOWN IN THIS LIST: 1. THE PART NUMBER 2. THE PART DESCRIPTION 3. THE MODEL NUMBER: 6039HF 4. THE SERIAL NUMBER:____________________ HOW TO ORDER REPAIR PARTS United States Stove Company 227 Industrial Park Road P.O.

United States Stove Hearth Focus 6039HF Owner's Manual

Quick Links

Related Manuals for United States Stove Hearth Focus 6039HF

Summary of Contents for United States Stove Hearth Focus 6039HF

Table of Contents