Step 2 Attach Platform To Legs; Step 3 Attach Weight Plate To Base - Charmglow 200605 Owner's Manual

7
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 2 – Attach Platform to Legs
Line up hole in Clip with small threaded hole on bottom of Platform .
Attach Clip loosely to Platform with () Large Screw .
Note: Do not tighten until step 9 .
Using 7/6" wrench, secure Platform to Legs using (2) Small Bolts, (2)
Small Lock Washers and (2) Small Nuts per Leg . Tighten fully .
Fully tighten all nuts and bolts from Step  .
TIP:
To tighten use a 7/6" wrench on Bolt and a 7/6" socket wrench on
Nut .
Step 3 – Attach Weight Plate to Base
Lay Base Assembly on its side .
Place Weight Plate in Base, feet out .
Note: If you plan to anchor your heater permanently, be sure to line up
two outer holes in Base with those in Weight Plate so that your anchor
bolt will pass through both holes .
Insert Carriage Bolt through center holes of Base and Plate .
Using 9/6" wrench, secure Plate to Base using () Large Lock Washer
and () Large Nut .
Place Base Assembly upright .
Owner's manual: model 200605 outdoor patio heater