Whirlpool MKC2157 Installation Instructions Manual page 6

Hide thumbs Also See for MKC2157:
Table of Contents

Advertisement

Available languages

Available languages

1.
InstGll Trim Kit F ame
Position trim kit frame over the opening so that the upper tabs
fit inside the rails, as shown.
4. Secure trim kit frame to cutout/cabinet
by installing four long
wood screws (painted) into the pilot holes drilled in Step 3
above.
NOTES:
To ensure vertical centering, install the lower screws first.
To avoid damage to the trim kit frame, do not overtighten
screws.
2.
3.
A. Front of trim kit frame
B. Upper tab
C. Raft
D. Lower tab
To vertically center the trim kit frame, slide it upward, against
the opening, until the upper tabs catch against the top of the
rails.
Holding the trim kit frame firmly in place, use 7/64" drill to drill
four pilot holes into the front facing of the cutout/cabinet
through the mounting hole guides in the upper and lower
corners of the trim kit frame.
NOTES:
To ensure vertical centering, drill the lower holes first.
The holes will be drilled upward from the bottom, and
downward from the top at an angle of about 45 ° .
Installation is now complete. Replace any loose items that have
been removed from microwave oven cavity.
Save these Installation Instructions for future reference.
A
F
A. Trim kit frame
B. Upper tab
C. Rail
D. Cutout floor
E. Long wood screw (4 - painted)
F Mounting hole guide
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mkc2150

Table of Contents