Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Uniden Barracuda MC-4700
Summary of Contents for Uniden Barracuda MC-4700
- Page 2 RADIO BACK PANEL VIEW <t> NO.: MC-4700 MODEL PTY,LTD. SANTAONIC AGENCIES MADE IN TAIWAN SERIAL SERIAL NUMBER This above pictorialdisplay shows the location of the various accessory, antenna, and as well powerreceptacles, asthe SERIAL NUMBER. You are urged to recordyour model number and your SERIAL NUMBER in the...
-
Page 3: Specifications
GENERAL Channels Frequency Range Frequency Control Frequency Tolerance Frequency Stability Operating Temperature Range Microphone Input Voltage Current Drain Cabinet Dimensions (mm) Weight Antenna Connector Meter Indicators TRANSMITTER Power output Modulation Intermodulation Distortion SSB Carrier Suppression Unwanted Sideband Frequency Response Output Impedance SSB Filter Output Indicators SPECIFICATIONS... - Page 4 RECEIVER Sensitivity Selectivity Cross Modulation Image Rejection I.F. Frequency AM and SSB RF Gain Control Automatic Gain Control Squelch Noise Blanker Clarifier Range Audio Output Power Frequency Response Distortion Built-in Speaker External Speaker (Not Supplied) PA SYSTEM Power Output External Speaker for PA Santronic has combined superb workmanship and modern styling with the very latest state-of-art circuitry to bring you Barracuda.
- Page 5 ALL SOLID STATE: IC and Transistorized construction, with Iow current drain, for a long, trouble-free life. LARGE LED CHANNEL DISPLAY: LED (light emitting diode) display for ease of channel selection. CLEAN SIGNAL: Transmitter audio processing circuitry produces a clean signal with maximum legal modulation, for best range.
-
Page 6: Installation
techniques Loop(PLL) operation on all 10 channels. The PLL circuitry quency control. It is designed to meet the Department of Communications requirements applicable Radio Communication RB244 of the D.O.C. regulations defines operation are required to read and understand these regulations prior to operating this equipment. -
Page 7: Ground Connection
NOTE: See ground connection tail. 4. Connect the black wire to ground. Consult a marine electrician if in doubt. Any convenient location with 5. Mount the microphone hanger on the side of the unit or near the unit, using two screws supplied. -
Page 8: Remote Speaker
used has been specifically designed for marine applications. Before installing the transceiver in a boat, consult your dealer for information regard- ing an adequate grounding system and prevention of electrolysis between fittings in the hull and water. AC OPERATION To operate the transceiver from AC current as the power source, you will require a separate power supply capable of supplying 2.5 amps at a 13.8V DC output with a nominal input voltage of 240 volts AC, 50/60 Hz. - Page 9 With the audio volume level, rotate the Squelch control clockwise to the point CH88 INDICATOR TX/RX TWO COLOR INDICATOR CH'BB TXJRX uniden BARRtACUDA MC14700 CHANNEL SELECTOR SWITCH operat- and receiver For easier...
-
Page 10: Indicator Function
This feature If a receive signal is the receive input UNIDEN's marine the user to attain levels of gain con- UNIDEN's automatic modulation with monitoring of channel 88. -
Page 11: Maintenance And Adjustment
TX/RX INDICATOR: The TX/RX light in the upper right corner of the front panel lights in red color when the microphone button is pressed and transmitter is in operation. It lights in green color when the microphone button is released and the receiver is in operation. - Page 12 This Warrantygivesyou specificlegalrights, and you may also AGENCIES PTY. LTD. BRISBANE: 3/12 BANDALL ST SLACKS CREEK, OLD 4127 PHONE 07290 BELL STREET PERTH: BALACATTA PHONE: (09) 3443937 1986 Uniden Corporation 13 Garema Circuit, OR CONSEQUENTIAL to you. In the event THE ORIGINAL 1188 23 GEDDES ST., W.A.