IBM Aptiva 2124 Hardware Maintenance Service page 45

Power Supply
•
95 W or 145 W switchable high/low voltage power supply(145 W for 2139
only)
•
Standard ATX power supply with +5V standby power
Internal Cabling
•
Two 40-pin ribbon cables for hard disk drive and CD/DVD-ROM drive.
•
One 34-pin ribbon cable for AT diskette drive.
•
One 4-pin (2-wire) cable for hard disk drive light-emitting diode (LED).
•
One 3-pin (3-wire) cable for power light-emitting diode (LED).
•
One 2-pin (2-wire) cable for power switch.
•
One 4-pin modem voice-in/speaker-out cable.
Modem
•
56.6 Kbps ISA plug and play modem adapter card with data/fax/voice or
voice-less features.
•
Telephone line-out (RJ-11) connector.
•
Telephone line-in (RJ-11) connector.
Monitor
•
Super video graphics array (SVGA) monitor.
•
Compliant to VESA power saving mode.
•
Connector for a detachable grounded 3-wire power cord.
•
1.8-m (5.8-ft) attached signal cable.
•
Auto-sensing power input for 100 Vac to 240 Vac.
•
15" (13.6" viewable image size) monitor
−
0.28-mm dot pitch
−
Automatic scanning horizontal frequencies from 30KHz to 54KHz
and all vertical frequencies between 50Hz and 120Hz.
−
DDC2A/B support
•
15" (13.7" viewable image size) monitor
−
0.28-mm dot pitch
General Information 1-5