In this mounting method, the transducer is mounted directly to the
hull. At the location you have selected for mounting, apply epoxy
or air-free silicone rubber cement to the hull and to the face of the
transducer. Roll the transducer into place, making sure that there are
no air bubbles. Allow to set for at least 12 hours. The signal is trans-
mitted directly through the hull. Please note that this type of mount
cannot be used on double hull, foam cored, balsa cored, or similar
A transom mount transducer may also be used.
If you use this type of mounting with your MC800, you will have to
add an external temperature sensor to obtain water temperatures.
NO AIR BUBBLES
SOLI D FIBERGLASS
OR METAL HULL