Uniden DSS 2455 Quick Start Manual page 59

UP308BH (DSS2465) ENG OM 1/14/05
Command Function
then Repeat a Message*
then Playing incoming Messages
then Skipping a Message
then Deleting a Message
then Stop Operation
* For Repeat a Message function, press # then
repeat the previous message, or press # then
repeat the current message.
** For Memo Record and Greeting Message Record function, the first time you enter
the corresponding command, it starts the Recording function. If you want to stop
the recording, press
5) After the command has finished, you hear intermittent beeps indicating that the
system is in the command waiting mode. You may enter another command at this
time from the chart above.
6) When you are finished, hang up to exit the system. The answering system
automatically returns to standby.
Remote access with the handset
You can check your new incoming messages, skip, repeat, or delete your incoming
messages with the handset. For example, you can install the answering system in the
living room, and check your incoming message from a bedroom with the handset.
You can also use speakerphone on the handset for remote operation (see "Making and
receiving calls" on page 23).
• If you press
• When the answering system does not answer within 6 seconds, you hear a beep and the
phone will return to standby.
• The base's keypad is disabled during remote operation.
• When you receive a call, the remote operation is canceled.
• You can change the handset volume during a remote operation.
• During the remote operation "
11:48 AM Page 53
Command Function
then Answering System On
then Memo Record/Stop **
then Greeting Message Record/Stop **
then Answer System Off
then Help Guidance
within about four seconds to
after about four seconds to
then or .
before the answering system answers, the phone will return to standby.
" appears on the base.
[ 53 ]