Bottom Cover And Rubber Feet - HP Envy 13 Series Maintenance And Service Manual

Bottom cover and rubber feet

Table 5-1 Bottom cover and rubber feet descriptions and part numbers
Description
Bottom cover in pale gold finish
Bottom cover in natural silver finish
Bottom cover in nightfall black finish
Rubber foot kit for natural silver finish
Rubber foot kit for nightfall black finish
Rubber foot kit for pale gold finish
▲ Prepare the computer for disassembly
To remove the bottom cover and rubber feet:
1. Peel the one rubber foot off the bottom of the computer (1).
2. Remove the two Phillips M2.5 × 5.0 screws from the rear of the computer (2).
3. Remove the two Phillips M2.5 × 5.0 screws from the front of the computer (3), and then remove the
bottom cover (4).
Reverse this procedure to install the bottom cover and rubber feet.
38 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Spare part number
L94026-001
L94027-001
L94028-001
L94024-001
L94025-001
L94023-001
37).