Uniden ECO TERRA GMR635-2 User Manual

UT01915ZZ_1 11/28/03 12:20 PM Page 1
GMR635-2/GMR635-2CK Congratulations on your purchase of the Uniden
GMR635-2/GMR635-2CK (General Mobile Radio
Service) radio. This product is a lightweight, palm-
• 15 GMRS / 7 FRS Channels • Battery Level Meter
sized radio. Use it at sporting events to stay in
• Up to 6 Mile Range* • Channel Monitor
contact with family and friends, hiking, skiing,
• 5 Selectable Call Tone Alerts • Channel Scan
outdoors, or in a neighborhood watch for vital
• Backlit LCD Display
• Keypad Lock
communication.
• Battery Recharge Circuit • Roger Beep
This compact, state-of-the-art device is equipped
• NiMH Battery Pack and Charger • Key Beep
with many features.
(GMR635-2CK only)
Your package contains two GMR635 radios, two
rechargeable NiMH battery packs (#BP38), AC
adapter (#AC6248), Recharging cradle (#RC6348),
two belt clips and this reference guide.You may
operate the unit using the rechargeable NiMH
battery pack or 4 AAA alkaline batteries
(not included). The following optional accessories
may be purchased from your participating Uniden
dealer or call1-800-554-3988 or visit us on the web
at www.uniden.com. Use only Uniden accessories.
• NiMH Battery Pack - #BP38
• Recharging Cradle - #RC6348
* Range may vary depending on environmental and/or topographical conditions.
GMR635 RADIO
The GMR635-2/GMR635-2CK radio operates on
the General Mobile Radio Service (GMRS)
frequencies which require a Federal
Communication Commission license to operate.
For licensing information and application forms,
visit the FCC online at: www.fcc.gov/wtb/uls or
call the FCC hotline at 1-800-418-3676. If you
have any questions you can contact the FCC
direct at 1-888-225-5322.
Your GMR635-2/GMR635-2CK radio uses the
NiMH battery pack(included in GMR635-2CK) or
4 AAA alkaline batteries (not included). If alkaline
batteries are used, we recommend using high
quality alkaline batteries.
To install the NiMH battery pack:
1 Antenna 11 Charging LED's 1) Make sure your radio is OFF.
2) Remove the battery compartment door by
2 PTT (Push-To-Talk) Button 12 Battery Level Meter
pushing up the tab at the bottom of the
3 Monitor Key 13 Receive Indicator
compartment door allowing the door to be
4 Channel/Scan Up Key 14 Scan Indicator
removed.
5 Channel/Scan Down Key 15 Channel Indicator
3) Place the NiMH battery pack in the
6 Speaker 16 Volume Setting Indicator
compartment, making sure that the charge
7 Call/Select Key 17 GMRS/FRS Indicator
contacts are on the lower half of the battery
8 Volume Up Key 18 Transmit Indicator
pack and facing out. If the NiMH battery pack is
9 Power Key 19 Call Indicator
installed incorrectly, the radio will not operate.
10 Volume Down Key 20 Keypad Lock Indicator
4) Replace the battery compartment door.
5) The battery pack must be charged before using
for the first time. Place the GMR635 radio into
the charging cradle allowing 16 hours charging
time to fully charge the battery pack.
Note: Always make sure your battery pack is fully
discharged before recharging to prolong the life of
the battery pack. The LED will illuminate while the
radio is in the charging cradle.
To install 4 AAA alkaline batteries:
1) Make sure your radio is OFF.
OPTIONAL ACCESSORIES
2) Remove the battery compartment door by
pushing up the tab at the bottom of the
compartment door allowing the door to be
removed.
3) Install 4 AAA alkaline batteries (not included)
into the battery compartment. Be certain to
follow the + and – symbols in the compartment.
Installing the batteries incorrectly will prevent the
radio from operating.
4) Replace the battery compartment door.
USING THE CHARGING CRADLE
If you use the rechargeable NiMH battery pack, two
GMR635-2CK radios can be charged by using the
charging cradle.
FCC GMRS LICENSE
Make sure to turn the radio OFF before placing
the radio in the charging cradle. Otherwise the
battery level meter icon won't indicate properly.
1) Connect the AC adapter (# AC6248) to DC IN 9V
jack and to a standard 120V AC wall outlet.
2) Set the charging cradle on the desk or tabletop,
and place the radio in the charging cradle with
the keypad facing forward.
3) Make sure that the LED illuminates. Charge the
battery pack for 16 hours and remove the radio
from the charging cradle after charge.
INSTALL THE BATTERIES
Note: The charge indicator LED's will remain on as
long as the radios are left in the charger.
BATTERY LEVEL AND
LOW BATTERY ALERT
This unit has a battery level meter on the display to
indicate the status of the batteries. When the
batteries in the unit are low, the battery level meter
icon will flash. Replace the alkaline
batteries immediately or if you are using the NiMH
battery pack, you must recharge the battery in
order to continue using the radio.
Warning! To avoid the risk of personal injury or
property damage from fire or electrical shock, only
use the Uniden accessories specifically designated
for this product.
Talking on Your Radio
USING THE RADIO
To talk to others using the radio:
In order to get the most out of your new radio, read
1) Press and hold the PTT button and speak in a
this reference guide completely before attempting to
clear, normal voice about 2-3 inches away from
operate the unit.
the microphone. While you are transmitting, the
Turning the Radio On and Adjusting the Volume icon will appear on the display. To avoid
cutting off the first part of your transmission,
1) Press and hold the key to turn the unit ON,
pause slightly after pressing the PTT button
and increase the speaker volume by pressing the
before you start talking.
vol L key. To decrease the volume, press the vol
2) When you are finished speaking, release the PTT
M key.
button. You can now receive incoming calls. While
2) Press and hold the key again to turn the unit
receiving, the icon will appear on the display.
OFF.
Transmitting a Call Tone
Your GMR635-2/GMR635-2CK radio is equipped
Adjusting the Sound (Key Beeps)
with 5 selectable call tones that will be transmitted
Your radio emits a beep each time one of the when the call/sel key is pressed.
buttons or keys (except for the PTT button and
To select a call tone:
call/sel key) are pressed. To turn this sound OFF,
1) Enter the Menu. Advance through the Menu until
press and hold call/sel while turning ON the radio.
the call icon is shown on the display. The
Repeat this step to turn the sound ON.
current call tone number ( - ) will be
indicated.
Navigating through the Menu
2) Press the ch/scan L or M key to increase or
decrease the number to the desired call tone.
To access the advanced features of the
Each tone will be heard through the speaker.
GMR635-2/GMR635-2CK, your radio has a Menu
3) Exit the Menu.
function.
To transmit the selected call tone, press the
Normal Call Tone Key Lock Normal
call/sel key. The selected tone will automatically be
transmitted for a fixed length of time.
1-5 ON-OFF Channel Scan Feature
Your GMR635-2/GMR635-2CK radio has a channel
1) To enter the Menu, press and hold the call/sel
Scan feature that allows you to easily Scan all 22
key.
channels. When an active channel is detected, the
2) Additional presses of the call/sel key will
unit will pause on that channel until the channel is
advance you through the Menu until exiting to
clear. Then after a 2 second delay, the unit will
"Normal" operating mode.
continue scanning. Pressing PTT while the Scan is
3) Other methods of exiting the Menu function are: paused on a channel will allow you to transmit on
a. Press PTT, mon, or vol L/M.
that channel.
b. Wait 10 seconds until the unit automatically
To turn ON channel scanning:
returns to "Normal" mode.
Press and hold either the ch/scan L or M key
until the scan icon is displayed. The channel
number on the display will change as the radio
Choosing a Channel
rapidly cycles through the channels.
Your radio has 22 channels you can use to talk to
To turn OFF channel scanning:
others. In order to speak to someone, each of you
must be set to the same channel. Press call/sel, or PTT.
To choose a channel:
Keypad Lock
With the radio in "Normal" operating mode press
the ch/scan L or M key to increase or decrease
To Lock the keypad:
the channel number displayed.
1) Enter the Menu. Advance through the Menu until
Note: Channels 1-7 have an expectancy range of
the icon appears on the display. The current
up to 6 miles. Channels 8-14 have an expectancy
key Lock status (OFF) blinks on the display.
range of up to 2 miles. Channels 15-22 have an
2) To switch the key Lock mode from OFF to ON,
expectancy range of up to 6 miles.
press the ch/scan L key.
3) To confirm the setting, press the call/sel key. The
radio returns to the "Normal" mode.
Note: If you exit the setting mode before confirming
your selection by pressing the call/sel key, the key
Lock setting will be set to OFF.
To Unlock the keypad:
1) Press and hold the key to turn the unit OFF.
2) Press and hold the key again to turn the unit
ON. The keypad is unlocked.
Automatic Power Save Feature
Your GMR635-2/GMR635-2CK radio has a unique
circuit designed to dramatically extend the life of the
batteries.
If there is no transmission nor an incoming call
within 3 seconds, your radio switches to the Power
Save mode. The radio is still able to receive
transmissions in this mode.
LCD Backlight
The LCD backlight will automatically turn ON when
any key (except PTT button) is pressed. The LCD
display will illuminate for 10 seconds before turning
OFF.
Monitor Mode Feature
Your GMR635-2/GMR635-2CK radio allows you to
listen for weak signals on the current channel at the
press of a key.
To turn ON the monitor mode:
• Press mon for brief listening, the icon will
blink.
• Press and hold mon for 2 seconds for continuous
listening. The receiver circuit will stay open, and
letting in both the noise & weak signals.
To turn OFF monitor mode:
• Press mon to return to "Normal" mode, and the
icon stops blinking.
Roger Beep
Roger Beep is a BEEP that is sent to notify the end
of transmission.
Roger Beep can be heard through the speaker
when Key Beep is on.
Roger Beep is transmitted even if key beep is turned
off. However Roger Beep will not be heard from the
speaker.
To turn OFF Roger Beep: Press and hold the
ch/scan L key while turning ON the radio.
To turn ON Roger Beep: Press and hold the
ch/scan L key while turning the radio ON again.