Mute Microphone; Tone Dialing Switch-Over (Australia Only); Traveling Out-Of-Range - Uniden 2315+2 Quick Start Manual

UP409ZH (WDECT2315-2) OM 12/22/05
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number
can be stored in a
memory location.
This is referred to as
Chain Dialing (see
page 35)
[ 24 ]
3:27 PM Page 24

MUTE MICROPHONE

You can temporarily turn off the microphone so that the person you are talking with
cannot hear you.
1) Press /del during talk mode (while phone is in use).
2) Press /vol/ or /vol/
and appear in the display. To cancel muting, repeat above step again
when Mute is set to on,

TONE DIALING SWITCH-OVER (AUSTRALIA ONLY)

Some telephone companies use equipment that requires pulse
dialing (sometimes referred to as rotary dialing). If you need
to enter tone dialing digits, you can switch-over to tone
dialing during the call. This feature is useful when you need
tone dialing to use automated systems, for example, entering
your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once
your call connects, press
number. These digits will be sent as tone dialing. Once the call ends, the tone mode is
canceled and pulse dialing mode resumes.

TRAVELING OUT-OF-RANGE

During a call, as you begin to move your handset too far from your base unit, noise
may increase. If you pass the range limits of the base unit, you will hear a beep and
see on the display, and then the handset returns to standby mode.
You may return to the call if you move your handset within the range limits of the
base and press or
to move the pointer to and then
appears.
. Enter the desired
speaker within 30 seconds.
.